Difficulty

Easy

Steps

8

Time Required

                          10 - 20 minutes

Sections

1

  • Front and/or back housing
  • 8 steps

Flags

0

  • BackPhilips Norelco 5801XL

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Front and/or back housing
  • Remove the two T8 2 mm Phillips screws on the back housing.

Remove the two T8 2 mm Phillips screws on the back housing.

1024

Step 2

  • Separate the back housing and the front housing using the plastic opening tool.

Separate the back housing and the front housing using the plastic opening tool.

Step 3

  • Using the plastic opening tool, carefully pry the inside of the middle bracket towards the outside of the housing in order to remove it.

Using the plastic opening tool, carefully pry the inside of the middle bracket towards the outside of the housing in order to remove it.

Step 4

  • Remove the two T8 2 mm screws near the bottom of the device.
  • Remove the bracket the screws were holding in place.

Remove the two T8 2 mm screws near the bottom of the device.

Remove the bracket the screws were holding in place.

Step 5

  • Insert the plastic opening tool into the charging port and push inwards.

Insert the plastic opening tool into the charging port and push inwards.

Step 6

  • Remove the two T8 2 mm screws near the top of the device shown here.

Remove the two T8 2 mm screws near the top of the device shown here.

Step 7

  • Cautiously lift and twist the circuit board, then begin sliding the inside assembly forward.
  • After sliding it forward, the whole assembly will separate from the rear housing.

Cautiously lift and twist the circuit board, then begin sliding the inside assembly forward.

After sliding it forward, the whole assembly will separate from the rear housing.

Step 8

  • The housing and the inside assembly should be completely separated.

The housing and the inside assembly should be completely separated.

Now, you can put the new housing on. To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 7 other contributors 


                    Ben Gibbs

Member since: 02/16/2016

361 Reputation

                                      3 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       IUPUI, Team 3-2, Harley Spring 2016                        

                                                  Member of IUPUI, Team 3-2, Harley Spring 2016 



                    IUPUI-HARLEY-S16S3G2                     


                                            4 Members                     


                                            3 Guides authored