Philips Pd9000 37 White Outer Housing Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          30 minutes

Sections

White Outer Housing
4 steps

Flags

BackPhilips PD9000 37
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              White Outer Housing

Lay the player flat so the bottom outside is showing. Using the Phillips #0 screwdriver, unscrew all the housing screws on the bottom of the player.
Have the player sitting upright, remove the rubber stoppers in order to get to the screw. Unscrew the inside screws by the screen using the Philips #0 screwdriver.
Remove the rubber stoppers for the bottom two screws as well. Unscrew the middle two screws.

Lay the player flat so the bottom outside is showing. Using the Phillips #0 screwdriver, unscrew all the housing screws on the bottom of the player.

Have the player sitting upright, remove the rubber stoppers in order to get to the screw. Unscrew the inside screws by the screen using the Philips #0 screwdriver.

Remove the rubber stoppers for the bottom two screws as well. Unscrew the middle two screws.

1024

Step 2

Open the disc flap and remove the screws inside with the Phillips #0 screwdriver. There will be three screws.

Open the disc flap and remove the screws inside with the Phillips #0 screwdriver. There will be three screws.

Step 3

Start removing the inside black face plate of the player by using a prying method between the white outer housing and the black face plate with a metal spudger.
Pull the black face plate off once you have pried it from the white housing. The bottom inside layer should pop off.
Using the same prying method with the metal spudger, start prying off the screens white outer housing.

Start removing the inside black face plate of the player by using a prying method between the white outer housing and the black face plate with a metal spudger.

Pull the black face plate off once you have pried it from the white housing. The bottom inside layer should pop off.

Using the same prying method with the metal spudger, start prying off the screens white outer housing.

Step 4

The light panel on the front can just pop right off.
To remove the metal bar against the battery, unscrew the screws with the phillips #0 screwdriver.
After unscrewing you can just lift the metal bar off.

The light panel on the front can just pop right off.

To remove the metal bar against the battery, unscrew the screws with the phillips #0 screwdriver.

After unscrewing you can just lift the metal bar off.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    Julia Sheremet

Member since: 09/28/2015

291 Reputation

                                      2 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Eastern Washington University, Team 1-3, Matresse Fall 2015                        

                                                  Member of Eastern Washington University, Team 1-3, Matresse Fall 2015 



                    EWU-MATRESSE-F15S1G3                     


                                            3 Members                     


                                            4 Guides authored

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team