Philips Respironics System One Remstar Blower Unit Replacement Repair Guide

Difficulty

Moderate

Steps

5

Time Required

                          10 minutes            

Sections

1

• Blower Unit
• 5 steps

Flags

2

Missed a Step

Oops! This guide is currently missing some important steps.

Better Introduction

Improve this guide by completing or revising its introduction.

• BackPhilips Respironics System One REMstar

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              Blower Unit               

• Turn the device upside down so that the rubber feet are facing you.
• Use the TR15 screw head to remove the two 46.5mm length crews located on the back.
• Gently remove the casing so that the wires are not damaged.

Turn the device upside down so that the rubber feet are facing you.

Use the TR15 screw head to remove the two 46.5mm length crews located on the back.

Gently remove the casing so that the wires are not damaged.

1024

Step 2

• Using a Torx TR10 screwdriver, remove the seven 13.5 mm screws that are securing the inner casing.
• Remove the inner casing.

Using a Torx TR10 screwdriver, remove the seven 13.5 mm screws that are securing the inner casing.

Remove the inner casing.

Step 3

• Remove the motor from the bottom half of the inner casing and set it to the side.

Remove the motor from the bottom half of the inner casing and set it to the side.

Step 4

• Remove the circular piece by popping it off to separate the circuit board from the top cover.
• No tools should be necessary to complete this action.

Remove the circular piece by popping it off to separate the circuit board from the top cover.

No tools should be necessary to complete this action.

Step 5

• Disconnect the green and red wire connectors from their white connectors to disconnect the blower motor.

Disconnect the green and red wire connectors from their white connectors to disconnect the blower motor.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 1 other contributor 

                    Travis Lott                     

Member since: 09/16/2020

175 Reputation

                                      1 Guide authored                  



                       Badges:
                       7







                                                        +4 more badges                           

Team

                       The Citadel Military College of South Carolina, Team S1-G1, Eggleston Fall 2020                        

                                                  Member of The Citadel Military College of South Carolina, Team S1-G1, Eggleston Fall 2020 



                    CMCSC-EGGLESTON-F20S1G1                     


                                            3 Members                     


                                            2 Guides authored                     

Charles Marshall - Jul 13, 2021

Reply

These steps may be out of sequential order. Step 4 should probably be Step 1 and perhaps some are even missing.