Philips Respironics V60 Fan Replacement Repair Guide

Difficulty

Moderate

Steps

10

Time Required

                          25 minutes            

Sections

4

• How to power down a Philips Respironics V60
• 2 steps
• How to Disconnect a Philips Respironics V60
• 2 steps
• Top Cover
• 2 steps
• Fan
• 4 steps

Flags

1

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

• BackPhilips Respironics V60

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

For more information on replacing the fan, please refer to page 9-6 in the service manual.

What you need

Step 1

              shut down the ventilator               

• Press and release the ON/Shutdown key, opening the Shutdown window in the screen.
• Select Ventilator Shutdown, which will shut down the ventilator.
• Improper shutdown may cause a Power has been restored message the next time the ventilator is turned on.

Press and release the ON/Shutdown key, opening the Shutdown window in the screen.

Select Ventilator Shutdown, which will shut down the ventilator.

Improper shutdown may cause a Power has been restored message the next time the ventilator is turned on.

1024

Step 2

              disconnect from power               

• Disconnect the ventilator from the AC power.

Disconnect the ventilator from the AC power.

Step 3

              How to Disconnect a Philips Respironics V60               

• Unplug the ventilator

Unplug the ventilator

Step 4

• Disconnect the internal battery from the power harness connector.

Disconnect the internal battery from the power harness connector.

Step 5

              Top Cover               

• Turn the captive D-ring fastener on the bottom of the panel counter-clockwise one-quarter turn and release.
• Then remove the right side panel.

Turn the captive D-ring fastener on the bottom of the panel counter-clockwise one-quarter turn and release.

Then remove the right side panel.

Step 6

• Remove the 4 screws using a screwdriver.
• Remove the top cover.

Remove the 4 screws using a screwdriver.

Remove the top cover.

Step 7

              Fan               

• Remove the fan mount push pins that attach the fan to the back panel.
• Pliers may be required.

Remove the fan mount push pins that attach the fan to the back panel.

Pliers may be required.

Step 8

• Disconnect fan cable from motor controller.

Disconnect fan cable from motor controller.

Step 9

• Remove fan,
• from back panel.

Remove fan,

from back panel.

Step 10

• Remove fan filter assembly (the fan filter and housing), from outside the back panel.
• When installing, orient the fan with the fan cable at the top inside of the fan, and orient the fan filter and housing as shown.

Remove fan filter assembly (the fan filter and housing), from outside the back panel.

When installing, orient the fan with the fan cable at the top inside of the fan, and orient the fan filter and housing as shown.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Rie Kuraoka                     

Member since: 01/23/2020

862 Reputation

                                      7 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges                           

Team

                       Cal Poly, Team S7-G10, Paton Spring 2020                        

                                                  Member of Cal Poly, Team S7-G10, Paton Spring 2020 



                    CPSU-PATON-S20S7G10                     


                                            2 Members                     


                                            9 Guides authored