Pioneer Elite Pro Ro6U Control Panel Circuit Board Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

                          25 - 30 minutes            

Sections

1

• Control Panel Circuit Board
• 8 steps

Flags

0

• BackPioneer Elite PRO-RO6U

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Control Panel Circuit Board               

• Remove the two 6.4 mm Phillips screws on each side of the device’s casing.

Remove the two 6.4 mm Phillips screws on each side of the device’s casing.

1024

Step 2

• Remove the two 6.5 mm Phillips screws on the back of the device casing.

Remove the two 6.5 mm Phillips screws on the back of the device casing.

Step 3

• Grip the front panel in one hand and the back of the casing in the other. Pull the casing back, and slide it up and away from the inner box.

Grip the front panel in one hand and the back of the casing in the other. Pull the casing back, and slide it up and away from the inner box.

Step 4

• Unlatch the three plastic connectors on the top of the receiver that hold the front panel to the device casing.

Unlatch the three plastic connectors on the top of the receiver that hold the front panel to the device casing.

Step 5

• The connectors on the bottom of the device may be very stiff and could require the use of a plastic prying tool.
• Carefully flip the device over and unlatch the three plastic connectors that hold the front panel to the bottom of the device casing.

The connectors on the bottom of the device may be very stiff and could require the use of a plastic prying tool.

Carefully flip the device over and unlatch the three plastic connectors that hold the front panel to the bottom of the device casing.

Step 6

• Grip and unplug the ribbon connector that connects the front circuit board to the device.

Grip and unplug the ribbon connector that connects the front circuit board to the device.

Step 7

• Unscrew the three 1/4 Phillips head screws on the back of the front circuit board.

Unscrew the three 1/4 Phillips head screws on the back of the front circuit board.

Step 8

• Grip the circuit board and slide towards the front side of the plastic casing.
• Lift upwards to remove the circuit board from the front panel.

Grip the circuit board and slide towards the front side of the plastic casing.

Lift upwards to remove the circuit board from the front panel.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Cody Carter                     

Member since: 01/30/2018

1,049 Reputation

                                      6 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges                           

Team

                       Baylor, Team S1-G5, Johnson Spring 2018                        

                                                  Member of Baylor, Team S1-G5, Johnson Spring 2018 



                    BU-JOHNSON-S18S1G5                     


                                            3 Members                     


                                            6 Guides authored