Pioneer Elite Pro Ro6U Optical Drive Cooling Fan Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          15 - 20 minutes            

Sections

1

• Optical Drive Cooling Fan
• 7 steps

Flags

0

• BackPioneer Elite PRO-RO6U

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

cooling fan will make it difficult for the media receiver to dissipate heat, and is the most likely cause of overheating. This guide will show you how to replace the optical drive cooling fan.

What you need

Step 1

              Optical Drive Cooling Fan               

• Remove the two 6.4 mm Phillips screws on each side of the device’s casing.

Remove the two 6.4 mm Phillips screws on each side of the device’s casing.

1024

Step 2

• Remove the two 6.5 mm Phillips screws on the back of the device casing.

Remove the two 6.5 mm Phillips screws on the back of the device casing.

Step 3

• Grip the front panel in one hand and the back of the casing in the other. Pull the casing back, and slide it up and away from the inner box.

Grip the front panel in one hand and the back of the casing in the other. Pull the casing back, and slide it up and away from the inner box.

Step 4

• To replace the optical drive cooling fan, grip the ribbon connector at M11 and gently remove by pulling away for the slot.

To replace the optical drive cooling fan, grip the ribbon connector at M11 and gently remove by pulling away for the slot.

Step 5

• Flip the latch on the ribbon connector upward to allow for cable removal.
• Grip the ribbon cable and remove by gently pulling away from the unlatched connector.

Flip the latch on the ribbon connector upward to allow for cable removal.

Grip the ribbon cable and remove by gently pulling away from the unlatched connector.

Step 6

• Remove the two 6.4 mm Phillips mounting screws on the optical drive cooling fan.

Remove the two 6.4 mm Phillips mounting screws on the optical drive cooling fan.

Step 7

• Grip the frame of the cooling fan and slide it toward the front panel, then lift out of the device.

Grip the frame of the cooling fan and slide it toward the front panel, then lift out of the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Cody Carter                     

Member since: 01/30/2018

1,049 Reputation

                                      6 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges                           

Team

                       Baylor, Team S1-G5, Johnson Spring 2018                        

                                                  Member of Baylor, Team S1-G5, Johnson Spring 2018 



                    BU-JOHNSON-S18S1G5                     


                                            3 Members                     


                                            6 Guides authored