Difficulty
Moderate
Steps
6
Time Required
10 - 15 minutes
Sections
1
- Power Supply Board
- 6 steps
Flags
0
BackPioneer Elite PRO-RO6U
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Power Supply Board
- Remove the two 6.4 mm Phillips screws on each side of the device’s casing.
Remove the two 6.4 mm Phillips screws on each side of the device’s casing.
1024
Step 2
- Remove the three 6.5 mm Phillips screws on the back of the device casing.
Remove the three 6.5 mm Phillips screws on the back of the device casing.
Step 3
- Grip the front panel in one hand and the back of the casing in the other. Pull the casing back, and slide it up and away from the inner box.
Grip the front panel in one hand and the back of the casing in the other. Pull the casing back, and slide it up and away from the inner box.
Step 4
- Gently pull upward and unplug cables D4 and D5.
Gently pull upward and unplug cables D4 and D5.
Step 5
- Remove the two 7/16 inch Phillips screws to the left and right of the power supply port.
- Remove three 5/16 inch Phillips screws from the corners of the board.
Remove the two 7/16 inch Phillips screws to the left and right of the power supply port.
Remove three 5/16 inch Phillips screws from the corners of the board.
Step 6
- Remove the power supply board by pulling it toward the interior of the device then lifting.
Remove the power supply board by pulling it toward the interior of the device then lifting.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Cody Carter
Member since: 01/30/2018
1,049 Reputation
6 Guides authored
Badges:
5
+2 more badges
Team
Baylor, Team S1-G5, Johnson Spring 2018
Member of Baylor, Team S1-G5, Johnson Spring 2018
BU-JOHNSON-S18S1G5
3 Members
6 Guides authored
