Difficulty
Moderate
Steps
5
Time Required
25 minutes
Sections
1
- Disk Drive
- 5 steps
Flags
0
BackPioneer FH-X730BS
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Disk Drive
- Apply pressure to the tabs on each side using the plastic opening tool.
- You will need to pull the face away from the frame while unhooking the tabs.
Apply pressure to the tabs on each side using the plastic opening tool.
You will need to pull the face away from the frame while unhooking the tabs.
1024
Step 2
- After removing the stereo face from the frame, it should look similar to this.
After removing the stereo face from the frame, it should look similar to this.
Step 3
- Remove the ribbon wire from where it is being held in place. This can be done by applying force upwards.
Remove the ribbon wire from where it is being held in place. This can be done by applying force upwards.
Step 4
- Unscrew the four 7.3 mm outer screws on the top to remove the top face from the rest of the frame.
Unscrew the four 7.3 mm outer screws on the top to remove the top face from the rest of the frame.
Step 5
- Unscrew the four inner screws that are 7.3 mm long using a Phillips #1 head screw driver to remove the disk drive from the top face plate.
- Replace the old disk drive with a new one.
Unscrew the four inner screws that are 7.3 mm long using a Phillips #1 head screw driver to remove the disk drive from the top face plate.
Replace the old disk drive with a new one.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Cody Pesta
Member since: 09/17/2018
688 Reputation
6 Guides authored
Badges:
8
+5 more badges
Team
Washington State, Team S2-G4, Hope Fall 2018
Member of Washington State, Team S2-G4, Hope Fall 2018
WSU-HOPE-F18S2G4
3 Members
6 Guides authored
