Difficulty

Moderate

Steps

7

Time Required

                          15 - 20 minutes

Sections

1

  • Touch Screen
  • 7 steps

Flags

2

Incorrect Tools

Help make this guide better by using the correct tools in images and/or text.

Slice and Dice

The steps in this guide should be split up and made into a series of prerequisite guides.

  • BackPioneer R1

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Touch Screen
  • Insert your plastic spudger in the opening near the HDMI port.
  • Gently pry the back cover of the R1 from the the front by using the spudger along the edges.
  • Do not pull the back cover straight off the R1 as components of the speakers will be attached to both sides.

Insert your plastic spudger in the opening near the HDMI port.

Gently pry the back cover of the R1 from the the front by using the spudger along the edges.

Do not pull the back cover straight off the R1 as components of the speakers will be attached to both sides.

1024

Step 2

  • Lay the R1 flat like an open book.
  • This will prevent the speakers from becoming disconnected from the motherboard.

Lay the R1 flat like an open book.

This will prevent the speakers from becoming disconnected from the motherboard.

Step 3

  • Remove the tape that is holding the motherboard to the display and covering the cable attachments.
  • Peel back just the end of this tape to free the front facing camera.

Remove the tape that is holding the motherboard to the display and covering the cable attachments.

Peel back just the end of this tape to free the front facing camera.

Step 4

  • Remove the three 4 mm screws along the base of the motherboard with a Phillips #00 Screwdriver.

Remove the three 4 mm screws along the base of the motherboard with a Phillips #00 Screwdriver.

Step 5

  • Disengage the two cable locks using your spudger or your finger nail.
  • Slide the cable free from the disengaged lock.
  • Do not pull across the cables as this may tear and permanently damage it.

Disengage the two cable locks using your spudger or your finger nail.

Slide the cable free from the disengaged lock.

Do not pull across the cables as this may tear and permanently damage it.

Step 6

  • Insert your spudger between the LCD display and the touch screen.
  • Gently pry the LCD display from the the touchscreen by using the spudger along the edges.

Insert your spudger between the LCD display and the touch screen.

Gently pry the LCD display from the the touchscreen by using the spudger along the edges.

Step 7

  • Once disengaged, remove the LCD display from the touchscreen.

Once disengaged, remove the LCD display from the touchscreen.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Christopher Rosario

Member since: 02/17/2015

411 Reputation

                                      4 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       San Diego State, Team 1-1, Sheppard Winter 2015                        

                                                  Member of San Diego State, Team 1-1, Sheppard Winter 2015 



                    SDSU-SHEPPARD-W15S1G1                     


                                            3 Members                     


                                            7 Guides authored