Difficulty

Moderate

Steps

6

Time Required

Suggest a time??

Sections

2

  • Smart Plate
  • 4 steps
  • Top Cover
  • 2 steps

Flags

0

  • BackPlayStation 3

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Smart Plate
  • Use the tip of a spudger to remove the black rubber screw cover from the side of the PS3.
  • The screw cover may be underneath a warranty sticker. This sticker will change appearance, and show “VOID” after it has been removed.

Use the tip of a spudger to remove the black rubber screw cover from the side of the PS3.

The screw cover may be underneath a warranty sticker. This sticker will change appearance, and show “VOID” after it has been removed.

1024

Step 2

  • Remove the single 8.5 mm T10 Security Torx screw from the smart plate.

Remove the single 8.5 mm T10 Security Torx screw from the smart plate.

Step 3

  • Pull the smart plate toward the hard drive bay, then lift it off the body of the PS3.

Pull the smart plate toward the hard drive bay, then lift it off the body of the PS3.

Step 4

  • Be sure to keep track of the small metal bracket loosely held in the top cover, if equipped.

Be sure to keep track of the small metal bracket loosely held in the top cover, if equipped.

Step 5

              Top Cover
  • Remove the following seven screws:
  • Six 52 mm Phillips screws
  • One 30 mm Phillips screw

Remove the following seven screws:

Six 52 mm Phillips screws

One 30 mm Phillips screw

Step 6

  • Lift the top cover from its rear edge and rotate it toward the front of the PS3.
  • Remove the top cover.
  • There is a plastic hook located in a hole on the top back right hand side corner. Carefully push the plastic hook a bit from the rear of the machine with a spudger to release the rear right of the casing.

Lift the top cover from its rear edge and rotate it toward the front of the PS3.

Remove the top cover.

There is a plastic hook located in a hole on the top back right hand side corner. Carefully push the plastic hook a bit from the rear of the machine with a spudger to release the rear right of the casing.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      45 other people completed this guide.

Author

                                      with 7 other contributors 


                    Walter Galan

682,038 Reputation

                                      1,203 Guides authored                  



                       Badges:
                       54







                                                        +51 more badges