Difficulty

Moderate

Steps

10

Time Required

                          20 - 30 minutes

Sections

2

  • Case Separation
  • 8 steps
  • GPS Antenna Cable
  • 2 steps

Flags

0

  • BackPlayStation Vita

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Case Separation
  • Power off and remove the memory card.
  • Using a Phillips #00 screwdriver, remove the four 6.4mm screws on the back casing.

Power off and remove the memory card.

Using a Phillips #00 screwdriver, remove the four 6.4mm screws on the back casing.

1024

Step 2

  • Using your fingernail or a spudger, pry open the accessory port cover on the top of the device.
  • Using a Phillips #00 screwdriver, remove the two 5.4mm screws hidden beneath the accessory port cover.

Using your fingernail or a spudger, pry open the accessory port cover on the top of the device.

Using a Phillips #00 screwdriver, remove the two 5.4mm screws hidden beneath the accessory port cover.

Step 3

  • Remove the two 5.4mm Phillips #00 screws on the bottom of the device near the charging port.

Remove the two 5.4mm Phillips #00 screws on the bottom of the device near the charging port.

Step 4

  • Beginning at the sides of the device, use a plastic opening tool to separate the front and rear cases.
  • Continue working your way around the device gently prying it open.
  • There are still wires holding the front and rear cases together. You may damage the connections if you yank the cases completely apart.

Beginning at the sides of the device, use a plastic opening tool to separate the front and rear cases.

Continue working your way around the device gently prying it open.

There are still wires holding the front and rear cases together. You may damage the connections if you yank the cases completely apart.

Step 5

  • Gently separate the two cases, minding the battery and the touch screen controller connectors holding the two cases together.

Gently separate the two cases, minding the battery and the touch screen controller connectors holding the two cases together.

Step 6

  • Using a spudger, free the touch screen controller flex cable by gently prying up the connection.

Using a spudger, free the touch screen controller flex cable by gently prying up the connection.

Step 7

  • Free the battery cable by gently prying up on the connection with a spudger.

Free the battery cable by gently prying up on the connection with a spudger.

Step 8

  • Separate the front and rear cases.

Separate the front and rear cases.

Step 9

              GPS Antenna Cable
  • Using the pointy end of the spudger, gently pry the GPS antenna cable off the wireless card.

Using the pointy end of the spudger, gently pry the GPS antenna cable off the wireless card.

Step 10

  • Using the pointy end of a spudger, gently pry the GPS antenna cable off of the motherboard.
  • Deroute the GPS antenna cable out of the casing and remove it.

Using the pointy end of a spudger, gently pry the GPS antenna cable off of the motherboard.

Deroute the GPS antenna cable out of the casing and remove it.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Brittany McCrigler

Member since: 03/05/2012

87,796 Reputation

                                      132 Guides authored                  



                       Badges:
                       48







                                                        +45 more badges