Playstation Vr Band Adjuster Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          30 minutes            

Sections

1

• Band Adjuster
• 7 steps

Flags

Incorrect Tools

Help make this guide better by using the correct tools in images and/or text.

• BackPlayStation VR

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Band Adjuster               

• Use your hands to remove the foam piece in the headband.
• Use the iFixIt Opening Tool to pry the top and bottom trim pieces off of the rear band assembly.

Use your hands to remove the foam piece in the headband.

Use the iFixIt Opening Tool to pry the top and bottom trim pieces off of the rear band assembly.

1024

Step 2

• Remove a total of four 5 mm screws from inside the left and right sides of the headband using a Phillips #00 screwdriver.

Remove a total of four 5 mm screws from inside the left and right sides of the headband using a Phillips #00 screwdriver.

Step 3

• Remove three silver 5 mm screws that are securing the rear white cover of the band using a Phillips #00 screwdriver.

Remove three silver 5 mm screws that are securing the rear white cover of the band using a Phillips #00 screwdriver.

Step 4

• Remove the 6 mm screw from the retainer securing wires to the rear band assembly using a Phillips #00 screwdriver.
• Use a spudger to flip up the retaining flap connected to the rear LEDs.

Remove the 6 mm screw from the retainer securing wires to the rear band assembly using a Phillips #00 screwdriver.

Use a spudger to flip up the retaining flap connected to the rear LEDs.

Step 5

• Remove the single 5 mm screw from the center of the headband adjuster using a Phillips #00 screwdriver.

Remove the single 5 mm screw from the center of the headband adjuster using a Phillips #00 screwdriver.

Step 6

• Gently pry the adjuster assembly away from the rear headband using an opening tool.

Gently pry the adjuster assembly away from the rear headband using an opening tool.

Step 7

• Disassemble the adjuster assembly spring, small gear, large gear, and bracket in order to replace the broken component.

Disassemble the adjuster assembly spring, small gear, large gear, and bracket in order to replace the broken component.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 

                    Aaron Suttles                     

Member since: 09/20/2021

337 Reputation

                                      3 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge                           

Team

                       The Citadel Military College of South Carolina, Team 1-7, Eggleston Fall 2021                        

                                                  Member of The Citadel Military College of South Carolina, Team 1-7, Eggleston Fall 2021 



                    CMCSC-EGGLESTON-F21S1G7                     


                                            3 Members                     


                                            4 Guides authored