Plugging In Shure Sm58 Xlr Cable Repair Guide

Difficulty

Very easy

Steps

Time Required

                          30 seconds - 1 minute

Sections

XLR Cable Plug In
3 steps

Flags

BackShure SM58
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

Step 1

              XLR Cable Plug In

Make sure you have a proper three pin XLR cable.
Grab the female end of the cable (plug with three holes).

Make sure you have a proper three pin XLR cable.

Grab the female end of the cable (plug with three holes).

1024

Step 2

Line up the pins in the end of the microphone (microphone connecter) with the holes in the XLR cable.

Line up the pins in the end of the microphone (microphone connecter) with the holes in the XLR cable.

Step 3

Once the pins are aligned, push the cable into the bottom end of the microphone. You should hear a click.

Once the pins are aligned, push the cable into the bottom end of the microphone. You should hear a click.

To disconnect the cable from the microphone, follow the instructions in reverse.

Cancel: I did not complete this guide.

                                                                                      13 other people completed this guide.

Author

                                      with 5 other contributors

                    nat coll

Member since: 09/27/2012

609 Reputation

                                      14 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       Cal Poly, Team 7-53, Forte Fall 2012                        

                                                  Member of Cal Poly, Team 7-53, Forte Fall 2012 



                    CPSU-FORTE-F12S7G53                     


                                            5 Members                     


                                            18 Guides authored

harrywwc - Jan 13, 2016

When disconnecting the cable - press the little latch (pointing towards you in the last picture) to release and then pull the cable out.

s6963172 - Jan 14, 2016

Is this April’s fool? XD

Santiago Morales - Jan 14, 2016

how i repair the PG48 the XLR conector moves in and out when the cable ar plugged. The conector male in the microphone have an screw but that one not works…

What am i do?

If you have an idea to the answer or any tip to resolve this trouble feel fre to tweet me.

@ Theradioholic

#Twitter

jimboc - Jan 15, 2016

I know a few people who would see this and still screw it up.

Michael Fox - Jan 15, 2016

do it in reverse? you have to press the button though on the male end…

Introduction#

#

#

#

#

#

Team#

#

Introduction

Team