Difficulty

Moderate

Steps

10

Time Required

                          10 - 15 minutes

Sections

2

  • Battery
  • 4 steps
  • Button
  • 6 steps

Flags

3

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

In Progress

This guide is a work in progress. Reload periodically to see the latest changes!

Needs More Images

A few more images would make this guide’s procedures crystal clear.

  • BackPokewalker

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Locate the Screw on the Back of the Pokewalker.

Locate the Screw on the Back of the Pokewalker.

1024

Step 2

  • Remove the Screw with a Phillips #0 Screwdriver
  • The screw is attached to the rear case with washers. don’t worry about losing it.

Remove the Screw with a Phillips #0 Screwdriver

The screw is attached to the rear case with washers. don’t worry about losing it.

Step 3

  • Remove the Rear Cover from the Device

Remove the Rear Cover from the Device

Step 4

  • Use the flat end of a Spudger to Remove the Battery

Use the flat end of a Spudger to Remove the Battery

Step 5

              Button
  • Locate the 4 Screws Around the Device

Locate the 4 Screws Around the Device

Step 6

  • Remove all 4 screws with a Y0 Triwing Screwdriver

Remove all 4 screws with a Y0 Triwing Screwdriver

Step 7

  • Separate the 2 halves of the Device
  • Do not Separate Completely as the Display is Still Connected by a Ribbon Cable

Separate the 2 halves of the Device

Do not Separate Completely as the Display is Still Connected by a Ribbon Cable

Step 8

  • Use a Spudger to Flip the Latch holding the ribbon cable in place and use Tweezers to Pull it out
  • Do not use Excessive force when reinserting the cable, because ribbon cables are fragile

Use a Spudger to Flip the Latch holding the ribbon cable in place and use Tweezers to Pull it out

Do not use Excessive force when reinserting the cable, because ribbon cables are fragile

Step 9

  • Remove the Rubber-button thingy from the upper case
  • I have no idea what that thing is, edit this guide if you do.

Remove the Rubber-button thingy from the upper case

I have no idea what that thing is, edit this guide if you do.

Step 10

  • Remove the 3 Plastic Buttons from the Case
  • It helps that the buttons only go in one way, makes it easier to reassemble

Remove the 3 Plastic Buttons from the Case

It helps that the buttons only go in one way, makes it easier to reassemble

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Winni Stuart

Member since: 04/13/2014

397 Reputation

                                      2 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges