Polaroid A10 Battery Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          20 - 30 minutes

Sections

Back Cover
1 step
Battery
3 steps

Flags

BackPolaroid A10
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Cover

Begin by having the side with volume and power button face up towards you.
Insert a plastic opening tool between the display and the back cover.
Once you have one plastic opening tool in, you can insert another one. While holding one in place, slide the other along the gap to release the tabs.
It is easier to remove the back cover, if the display screen is faced down.
The tabs must be released from all four sides before removing the back cover.

Begin by having the side with volume and power button face up towards you.

Insert a plastic opening tool between the display and the back cover.

Once you have one plastic opening tool in, you can insert another one. While holding one in place, slide the other along the gap to release the tabs.

It is easier to remove the back cover, if the display screen is faced down.

The tabs must be released from all four sides before removing the back cover.

1024

Step 2

              Battery

Begin by inserting the flat end of a spudger underneath the battery to separate the glue from the battery.
It is better to use a plastic card if you have one.
Gently lift up the battery as you continue to separate the glue from the battery.
Lift up just enough to see where the glue is, so that you don’t bend the battery.
Once the glue has been separated, gently lift up the battery and you will notice two wires attached to the motherboard.

Begin by inserting the flat end of a spudger underneath the battery to separate the glue from the battery.

It is better to use a plastic card if you have one.

Gently lift up the battery as you continue to separate the glue from the battery.

Lift up just enough to see where the glue is, so that you don’t bend the battery.

Once the glue has been separated, gently lift up the battery and you will notice two wires attached to the motherboard.

Step 3

Follow the (Black and Red) wires from the battery to the motherboard.
The two wires (Black and Red) must be removed from the motherboard, as they are connected to the battery.
Removal and installation of wires requires soldering. Here’s a helpful link to assist you with great soldering techniques.

Follow the (Black and Red) wires from the battery to the motherboard.

The two wires (Black and Red) must be removed from the motherboard, as they are connected to the battery.

Removal and installation of wires requires soldering. Here’s a helpful link to assist you with great soldering techniques.

Step 4

Gently lift the battery up and out of the device.

Gently lift the battery up and out of the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors

                    armando

Member since: 01/14/2015

150 Reputation

                                      1 Guide authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       UW Tacoma, Team 3-3, Rose Winter 2015                        

                                                  Member of UW Tacoma, Team 3-3, Rose Winter 2015 



                    UWT-ROSE-W15S3G3                     


                                            4 Members                     


                                            12 Guides authored

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team