Polaroid A10 Speakers Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          15 - 20 minutes

Sections

Back Cover
1 step
Speakers
4 steps

Flags

BackPolaroid A10
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Cover

Begin by having the side with volume and power button face up towards you.
Insert a plastic opening tool between the display and the back cover.
Once you have one plastic opening tool in, you can insert another one. While holding one in place, slide the other along the gap to release the tabs.
It is easier to remove the back cover, if the display screen is faced down.
The tabs must be released from all four sides before removing the back cover.

Begin by having the side with volume and power button face up towards you.

Insert a plastic opening tool between the display and the back cover.

Once you have one plastic opening tool in, you can insert another one. While holding one in place, slide the other along the gap to release the tabs.

It is easier to remove the back cover, if the display screen is faced down.

The tabs must be released from all four sides before removing the back cover.

1024

Step 2

              Speakers

The speakers are located on the bottom of the device, below the battery and adjacent to the motherboard.

The speakers are located on the bottom of the device, below the battery and adjacent to the motherboard.

Step 3

Using the Phillips #000 screwdriver, remove the two 7 mm screws located in the picture by rotating the screw counter-clockwise.
Carefully remove the speakers from original position without pulling out the wires.

Using the Phillips #000 screwdriver, remove the two 7 mm screws located in the picture by rotating the screw counter-clockwise.

Carefully remove the speakers from original position without pulling out the wires.

Step 4

Using the soldering tool, remove the two small black wires and two small red wires from the motherboard.
The wire connections are located on the motherboard next to the corner of the battery closest to the motherboard.
Removal and installation of wires requires soldering. Here’s a helpful link to assist you with great soldering techniques.

Using the soldering tool, remove the two small black wires and two small red wires from the motherboard.

The wire connections are located on the motherboard next to the corner of the battery closest to the motherboard.

Removal and installation of wires requires soldering. Here’s a helpful link to assist you with great soldering techniques.

Step 5

Gently lift the speakers up and out of the device.

Gently lift the speakers up and out of the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Koby

Member since: 01/22/2015

104 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       UW Tacoma, Team 3-3, Rose Winter 2015                        

                                                  Member of UW Tacoma, Team 3-3, Rose Winter 2015 



                    UWT-ROSE-W15S3G3                     


                                            4 Members                     


                                            12 Guides authored

amirahoresanwo - Feb 27, 2018

This is not what I meant I wanted to know what to do if the wires came out of the

If the wires and out of the

Speaker right

Introduction#

What you need#

Team#

Introduction

What you need

Team