Difficulty
Moderate
Steps
13
Time Required
15 - 45 minutes
Sections
2
- Battery
- 10 steps
- Lens
- 3 steps
Flags
0
BackPolaroid Cube
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Due to the thickness and width of the screws, make sure to carefully remove them using a screwdriver and a magnet pad.
What you need
Step 1
Battery
- Remove the SD card cover by twisting it using a Plastic Opening Tool
Remove the SD card cover by twisting it using a Plastic Opening Tool
1024
Step 2
- Use the Plastic Opening tool to pry off and remove the front cover.
Use the Plastic Opening tool to pry off and remove the front cover.
Step 3
- Using a J00 head screwdriver, remove the four 3.27mm screws from the front of the camera near the lens.
Using a J00 head screwdriver, remove the four 3.27mm screws from the front of the camera near the lens.
Step 4
- Use the Plastic Opening Tool to pry open the shell of the camera.
- There are four latches, one at each corner, that you will need to detach.
Use the Plastic Opening Tool to pry open the shell of the camera.
There are four latches, one at each corner, that you will need to detach.
Step 5
- Remove shell from top and bottom of camera.
Remove shell from top and bottom of camera.
Step 6
- Remove the rubber seal wrapped around the camera.
Remove the rubber seal wrapped around the camera.
Step 7
- Remove the tape wrapped around the battery.
Remove the tape wrapped around the battery.
Step 8
- Using a J00 head screwdriver, unscrew the four 3.46mm screws from the top and bottom circuit board.
Using a J00 head screwdriver, unscrew the four 3.46mm screws from the top and bottom circuit board.
Step 9
- Use the plastic opening tool to remove the circuit board that the battery is connected to.
Use the plastic opening tool to remove the circuit board that the battery is connected to.
Step 10
- Gently remove the battery pin connector from the circuit board.
Gently remove the battery pin connector from the circuit board.
Step 11
Lens
- Use a J00 screwdriver to unscrew the two circled 3.5mm Phillips-head screws from the circuit board.
Use a J00 screwdriver to unscrew the two circled 3.5mm Phillips-head screws from the circuit board.
Step 12
- Use a J00 head screwdriver to unscrew the two 3.5mm screws from the circuit board.
Use a J00 head screwdriver to unscrew the two 3.5mm screws from the circuit board.
Step 13
- Remove the lens from the unscrewed circuit board and replace the broken lens.
Remove the lens from the unscrewed circuit board and replace the broken lens.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
4 other people completed this guide.
Author
with 4 other contributors
Grant Baldwin
Member since: 09/29/2016
685 Reputation
2 Guides authored
Badges:
15
+12 more badges
Team
IUPUI, Team 3-2, Harley Fall 2016
Member of IUPUI, Team 3-2, Harley Fall 2016
IUPUI-HARLEY-F16S3G2
4 Members
3 Guides authored
Ben McAlister - Feb 24, 2018
Reply
Where can I find a replacement lens for the cube+? I broke the bubble part of the lens
starsas777 - May 15, 2018
Reply
Maybe is posable replace wider view angle lens ? original looks like fpv camera lens foxeer or runcam micro. Possibly Caddx micro cam lens
