Polaroid I835 Lcd Replacement Repair Guide

Difficulty

Moderate

Steps

3

Time Required

                          30 - 45 minutes            

Sections

1

• LCD
• 3 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

• BackPolaroid i835

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              LCD               

• remove the batteries, the memory card as well as the carrying strip (if so equipped).
• Remove the 2 screws on the right hand side.
• Remove the 2 screws on the left hand side.

remove the batteries, the memory card as well as the carrying strip (if so equipped).

Remove the 2 screws on the right hand side.

Remove the 2 screws on the left hand side.

1024

Step 2

• One more screw on the bottom, underneath the manufacturer’s label.
• Start spitting the case from the battery compartment. You can use a plastic opening tool, or your finger nails. It does bind a bit at the USB port side, but will separate pretty quick.
• With the back removed, the large LCD becomes immediately visible. There are no fasteners, it just rests inside the tray.

One more screw on the bottom, underneath the manufacturer’s label.

Start spitting the case from the battery compartment. You can use a plastic opening tool, or your finger nails. It does bind a bit at the USB port side, but will separate pretty quick.

With the back removed, the large LCD becomes immediately visible. There are no fasteners, it just rests inside the tray.

Step 3

• Lift the LCD out of the tray and move it to the right of the tray. The cable is still attached to the logic board via a latch.
• With the plastic opening tool, or your fingernails, gently flip the latch to the left side. This will free the LCD cable. Remove the LCD and install your new one.

Lift the LCD out of the tray and move it to the right of the tray. The cable is still attached to the logic board via a latch.

With the plastic opening tool, or your fingernails, gently flip the latch to the left side. This will free the LCD cable. Remove the LCD and install your new one.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    oldturkey03                     

Member since: 09/29/2010

722,317 Reputation

                                      109 Guides authored                  



                       Badges:
                       53







                                                        +50 more badges                           

Team

                       Global Fixers                        

                                                  Member of Global Fixers 



                    Community                     


                                            22 Members                     


                                            240 Guides authored