Polaroid Lcd 0700P Case Replacement Repair Guide

Difficulty

Easy

Steps

3

Time Required

                          5 minutes            

Sections

1

• Case
• 3 steps

Flags

Missed a Step

Oops! This guide is currently missing some important steps.

• BackPolaroid LCD-0700P

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              Case               

• Turn the entire device over, so that the underside of the device is facing upward.
• With the underside of the device facing up, locate the 11mm screw found in each far corner of the device. Remove the single 11mm screw from each of the four corners, using the Phillips #0 screwdriver.

Turn the entire device over, so that the underside of the device is facing upward.

With the underside of the device facing up, locate the 11mm screw found in each far corner of the device. Remove the single 11mm screw from each of the four corners, using the Phillips #0 screwdriver.

1024

Step 2

• Turn the device so that the underside faces you, and the edge where the case and device bind, faces upward. The opening of the device should be face down.
• In this position you will see a crease line between the device and the top cover. Gently Insert your blue plastic opening tool into the crack of the crease line, between the front and back cover to separate them.
• Be careful when separating the front and back covers, as the two are held together by a thin wire.
• Separate the halves of the case.

Turn the device so that the underside faces you, and the edge where the case and device bind, faces upward. The opening of the device should be face down.

In this position you will see a crease line between the device and the top cover. Gently Insert your blue plastic opening tool into the crack of the crease line, between the front and back cover to separate them.

Be careful when separating the front and back covers, as the two are held together by a thin wire.

Separate the halves of the case.

Step 3

• Locate the input/output board on the top left hand corner of the device. It will look like a green circuit board with wires protruding and connecting to the case cover.
• Using your blue plastic opening tool, disconnect the multicolored wires located on the input/output board. These will be the same multicolored wires that connect the back cover to the input/output board.

Locate the input/output board on the top left hand corner of the device. It will look like a green circuit board with wires protruding and connecting to the case cover.

Using your blue plastic opening tool, disconnect the multicolored wires located on the input/output board. These will be the same multicolored wires that connect the back cover to the input/output board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 8 other contributors 

                    Mario T                     

Member since: 01/09/2012

466 Reputation

                                      5 Guides authored                  



                       Badges:
                       14







                                                        +11 more badges                           

Team

                       Cal Poly, Team 8-14, Maness Winter 2012                        

                                                  Member of Cal Poly, Team 8-14, Maness Winter 2012 



                    CPSU-MANESS-W12S8G14                     


                                            4 Members                     


                                            8 Guides authored