Difficulty
Easy
Steps
6
Time Required
10 - 15 minutes
Sections
1
- Battery
- 6 steps
Flags
0
BackPortege Z830-S8302
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Flip the laptop over with the screen facing down to reveal the bottom panel.
- Unscrew each of the highlighted screws with a Phillips #0 screwdriver.
Flip the laptop over with the screen facing down to reveal the bottom panel.
Unscrew each of the highlighted screws with a Phillips #0 screwdriver.
1024
Step 2
- Use a metal spudger to remove fitting and reveal the screw.
- Use a screwdriver with a Torx T7 bit to remove the screw.
Use a metal spudger to remove fitting and reveal the screw.
Use a screwdriver with a Torx T7 bit to remove the screw.
Step 3
- The SD Card slot is on the top right corner of the device near the headphone jacks.
- Depress the fake SD Card and release.
- Pull the fake SD Card out and remove it completely from the slot, as this will help in the removal of the backplate.
The SD Card slot is on the top right corner of the device near the headphone jacks.
Depress the fake SD Card and release.
Pull the fake SD Card out and remove it completely from the slot, as this will help in the removal of the backplate.
Step 4
- Lift the back plate starting at the opposing edge to the SD card. Lift from left to right and continue lifting this plate at this angle until it’s free from the laptop.
- Once the backplate is completely off, this will reveal the inside components of the device.
- Upon reassembly of the back cover, make sure to line up the two headphone jacks on the upper right corner with the holes in the back cover or else it will not seat fully.
Lift the back plate starting at the opposing edge to the SD card. Lift from left to right and continue lifting this plate at this angle until it’s free from the laptop.
Once the backplate is completely off, this will reveal the inside components of the device.
Upon reassembly of the back cover, make sure to line up the two headphone jacks on the upper right corner with the holes in the back cover or else it will not seat fully.
Step 5
- The battery is the black rectangular piece in the bottom half of the device.
- Remove six 5mm screws holding down the battery using a Phillips PH0 screwdriver.
- Lift the battery and separate from its place holder.
- Do not fully remove the battery as it is still connected by the connector in the top right corner.
The battery is the black rectangular piece in the bottom half of the device.
Remove six 5mm screws holding down the battery using a Phillips PH0 screwdriver.
Lift the battery and separate from its place holder.
Do not fully remove the battery as it is still connected by the connector in the top right corner.
Step 6
- Using the nylon spudger, disconnect the white plugin.
- Once the wire has been disconnected you may remove the battery.
Using the nylon spudger, disconnect the white plugin.
Once the wire has been disconnected you may remove the battery.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Tanner Krygier
Member since: 09/17/2018
898 Reputation
5 Guides authored
Badges:
9
+6 more badges
Team
Washington State, Team S2-G7, Hope Fall 2018
Member of Washington State, Team S2-G7, Hope Fall 2018
WSU-HOPE-F18S2G7
3 Members
10 Guides authored
hairu nizam - Dec 24, 2020
Reply
can we still run it without battery? i mean using direct power supply and no battery install
