Porter Cable 382 Dust Seal Dust Break Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

Suggest a time??

Sections

Sander Pad
2 steps
Dust Seal/ Break
2 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

BackPorter-Cable 382
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

What you need

Step 1

              Sander Pad

When changing the sander pad, be sure to rotate the sander upside down so the pad and three highlighted screws are facing upward toward you.
Once the sander is upside down begin by removing your old sandpaper.
Once the sandpaper is removed locate the three screws on your sander pad.

When changing the sander pad, be sure to rotate the sander upside down so the pad and three highlighted screws are facing upward toward you.

Once the sander is upside down begin by removing your old sandpaper.

Once the sandpaper is removed locate the three screws on your sander pad.

1024

Step 2

Remove the three, (star bolt) screws with the iFixit screw driver with a “T20” head. Be sure to hold the pad of the sander as it will rotate as you try to loosen the screws.
Once the screws are removed pull upward toward you and the sander pad will come apart from the device.

Remove the three, (star bolt) screws with the iFixit screw driver with a “T20” head. Be sure to hold the pad of the sander as it will rotate as you try to loosen the screws.

Once the screws are removed pull upward toward you and the sander pad will come apart from the device.

Step 3

              Dust Seal/ Break

Once the sander pad is removed and the sander is exposed locate the white plastic like circular piece surrounding the outside of the sander.

Once the sander pad is removed and the sander is exposed locate the white plastic like circular piece surrounding the outside of the sander.

Step 4

Once you have located the plastic white ring pull up its outer edge as shown. The lip on the inside will bend and be freed from its secured placement.
To reassemble, you will have to line up the protruding square with the key slot as shown otherwise your dust seal/ brake will not go back in.

Once you have located the plastic white ring pull up its outer edge as shown. The lip on the inside will bend and be freed from its secured placement.

To reassemble, you will have to line up the protruding square with the key slot as shown otherwise your dust seal/ brake will not go back in.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    jpfoxracing9

Member since: 03/11/2016

189 Reputation

                                      1 Guide authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       UMass Dartmouth, Team 8-7, Botvin Spring 2016                        

                                                  Member of UMass Dartmouth, Team 8-7, Botvin Spring 2016 



                    UMASSD-BOTVIN-S16S8G7                     


                                            3 Members                     


                                            4 Guides authored

Better Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Better Introduction

What you need

Team