Porter Cable Pc60Tag Motor Brush Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

Suggest a time??

Sections

1

• Motor Brush
• 7 steps

Flags

Slice and Dice

The steps in this guide should be split up and made into a series of prerequisite guides.

• BackPorter-Cable PC60TAG

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Motor Brush               

• Using the Phillips #2 screwdriver, remove the 3/4" screw on the back cover.
• Unplug the grinder before disassembling.

Using the Phillips #2 screwdriver, remove the 3/4" screw on the back cover.

Unplug the grinder before disassembling.

1024

Step 2

• Holding the front of the device, carefully slide the back cover over the cord.

Holding the front of the device, carefully slide the back cover over the cord.

Step 3

• Using the Phillips #2 screwdriver, remove the 1/2" screw holding on the motor brush arm.

Using the Phillips #2 screwdriver, remove the 1/2" screw holding on the motor brush arm.

Step 4

• Carefully pull the motor brush arm away from the other device.

Carefully pull the motor brush arm away from the other device.

Step 5

• Using the spudger, carefully lift the spring on the motor brush arm off of the motor brush and gently pull it to the side of the motor bush arm.
• Be careful not to over bend the spring, as this could damage the spring and require replacement.

Using the spudger, carefully lift the spring on the motor brush arm off of the motor brush and gently pull it to the side of the motor bush arm.

Be careful not to over bend the spring, as this could damage the spring and require replacement.

Step 6

• Using the spudger, gently push the motor brush out of the arm.

Using the spudger, gently push the motor brush out of the arm.

Step 7

• Using a pair of needle nose pliers, gently pull the motor brush terminal off of the motor brush arm.
• Repeat steps 3-7 on the other side of the device.

Using a pair of needle nose pliers, gently pull the motor brush terminal off of the motor brush arm.

Repeat steps 3-7 on the other side of the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Mackenzie Fairbanks                     

Member since: 03/24/2016

564 Reputation

                                      5 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges                           

Team

                       UMass Dartmouth, Team 2-2, Isaacson Spring 2016                        

                                                  Member of UMass Dartmouth, Team 2-2, Isaacson Spring 2016 



                    UMASSD-ISAACSON-S16S2G2                     


                                            3 Members                     


                                            5 Guides authored