Difficulty

Easy

Steps

6

Time Required

                          15 - 30 minutes

Sections

2

  • Lever assembly
  • 4 steps
  • Housing
  • 2 steps

Flags

0

  • BackPorter-Cable PCC710B

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

If your device is experiencing issues that cannot be fixed with a simple cleaning or tightening of the tool’s blades, you’ll need to follow this guide to reach any malfunctioning parts.

Before beginning this guide, make sure the battery of the tool is taken off, you do not want any power source connected to the device while working on this replacement!

What you need

Step 1

              Lever assembly
  • Place the tool on its side so the orange and white warning label barcodes are facing up.
  • The lever and battery base of the tool should point toward you.

Place the tool on its side so the orange and white warning label barcodes are facing up.

The lever and battery base of the tool should point toward you.

1024

Step 2

  • Use a 5.5 mm nut driver to unscrew the Hex nut.
  • If the Hex nut is not unscrewing easily- you can use a 3 mm Hex head screwdriver to hold the other side of the screw still.

Use a 5.5 mm nut driver to unscrew the Hex nut.

If the Hex nut is not unscrewing easily- you can use a 3 mm Hex head screwdriver to hold the other side of the screw still.

Step 3

  • Flip the tool over and remove the black screw holding the tool together.
  • Get a good grip on the screw by using pliers to pull the screw out of the tool.

Flip the tool over and remove the black screw holding the tool together.

Get a good grip on the screw by using pliers to pull the screw out of the tool.

Step 4

  • Pinch the lever with your fingers and pull it up and away from the tool. The lever pops right off! You can squeeze on the lever, and it will come off just as easily.
  • When replacing your new lever assembly, make sure the black torsion (the black staple-like hinge) is oriented correctly.

Pinch the lever with your fingers and pull it up and away from the tool. The lever pops right off! You can squeeze on the lever, and it will come off just as easily.

When replacing your new lever assembly, make sure the black torsion (the black staple-like hinge) is oriented correctly.

Step 5

              Housing
  • Lay the tool on its side so that the grey and orange warning labels are facing up upwards.
  • Use the JIS #1 screwdriver to remove the 10 screws holding the tool together.

Lay the tool on its side so that the grey and orange warning labels are facing up upwards.

Use the JIS #1 screwdriver to remove the 10 screws holding the tool together.

Step 6

  • Lift the case off to access the internals of the tool.

Lift the case off to access the internals of the tool.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Alex Zapata

Member since: 09/19/2022

665 Reputation

                                      7 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       Austin Community College, Team 13-3, Watkins Fall 2022                        

                                                  Member of Austin Community College, Team 13-3, Watkins Fall 2022 



                    AUSTINCC-WATKINS-F22S13G3                     


                                            4 Members                     


                                            7 Guides authored