Difficulty
Moderate
Steps
4
Time Required
25 - 40 minutes
Sections
2
- Rear Housing
- 2 steps
- Brush
- 2 steps
Flags
0
BackPorter-Cable PCE211
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Before beginning this guide, be sure to turn the device off and unplug it from any power source.
What you need
Step 1
Rear Housing
- Remove the four 6 mm screws using a Phillips #2 screwdriver.
- The screws are tight so you will need to use a bit of arm strength.
Remove the four 6 mm screws using a Phillips #2 screwdriver.
The screws are tight so you will need to use a bit of arm strength.
1024
Step 2
- Pull the rear housing off the back of the impact wrench.
- Be careful when removing the rear case that loose parts don’t get damaged.
Pull the rear housing off the back of the impact wrench.
Be careful when removing the rear case that loose parts don’t get damaged.
Step 3
Brush
- Remove the brushes connected to the red and black cords.
- They are not secured so they made drop out naturally.
Remove the brushes connected to the red and black cords.
They are not secured so they made drop out naturally.
Step 4
- Gently pull each brush off the corresponding cable to avoid damaging the cables.
Gently pull each brush off the corresponding cable to avoid damaging the cables.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Layla Berry
Member since: 09/19/2022
657 Reputation
7 Guides authored
Badges:
7
+4 more badges
Team
Austin Community College, Team 13-1, Watkins Fall 2022
Member of Austin Community College, Team 13-1, Watkins Fall 2022
AUSTINCC-WATKINS-F22S13G1
3 Members
7 Guides authored
