Difficulty
Easy
Steps
2
Time Required
5 - 10 minutes
Sections
1
- Rear Housing
- 2 steps
Flags
0
BackPorter-Cable PCE211
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Prior to beginning this guide, be sure the impact wrench is off and unplugged from the power source.
Note: The screws holding the rear housing are fairly tight, so you will need some arm strength to remove them.
What you need
Step 1
Rear Housing
- Remove the four 6 mm screws using a Phillips #2 screwdriver.
- The screws are tight so you will need to use a bit of arm strength.
Remove the four 6 mm screws using a Phillips #2 screwdriver.
The screws are tight so you will need to use a bit of arm strength.
1024
Step 2
- Pull the rear housing off the back of the impact wrench.
- Be careful when removing the rear case that loose parts don’t get damaged.
Pull the rear housing off the back of the impact wrench.
Be careful when removing the rear case that loose parts don’t get damaged.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Layla Berry
Member since: 09/19/2022
657 Reputation
7 Guides authored
Badges:
7
+4 more badges
Team
Austin Community College, Team 13-1, Watkins Fall 2022
Member of Austin Community College, Team 13-1, Watkins Fall 2022
AUSTINCC-WATKINS-F22S13G1
3 Members
7 Guides authored
