Difficulty

Easy

Steps

5

Time Required

                          9 - 15 minutes

Sections

1

  • Phone Jack
  • 5 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackPower Macintosh G3 (Blue and White)

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Before opening up your Power Mac...
  • Remove the Phillips #1 screw circled in the picture. Set it aside for re-assembly.

Remove the Phillips #1 screw circled in the picture. Set it aside for re-assembly.

1024

Step 2

  • Unfortunately, I am unable to provide OG content for this step due to my Power Mac’s outer case being severely damaged. Once I get my new outer case I will update this step.
  • Lift the latch on the right side panel to reveal the internals.
  • If you are doing this on a hard surface I highly suggest you put a mat down between the door and the ground to prevent scratches.

Unfortunately, I am unable to provide OG content for this step due to my Power Mac’s outer case being severely damaged. Once I get my new outer case I will update this step.

Lift the latch on the right side panel to reveal the internals.

If you are doing this on a hard surface I highly suggest you put a mat down between the door and the ground to prevent scratches.

Step 3

  • Remove the single Phillips #1 screw circled in the picture.
  • I apologize for the lack of picture quality. The only camera and lighting I had were my iPhone X´s camera and a table lamp. Lol!

Remove the single Phillips #1 screw circled in the picture.

I apologize for the lack of picture quality. The only camera and lighting I had were my iPhone X´s camera and a table lamp. Lol!

Step 4

  • Disconnect the modem’s flex cable from the connector on the logic board.

Disconnect the modem’s flex cable from the connector on the logic board.

Step 5

  • Lift the modem assembly out of it´s place on the logic board.

Lift the modem assembly out of it´s place on the logic board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    [deleted]

Member since: 08/28/2018

24,746 Reputation

                                      21 Guides authored                  



                       Badges:
                       50







                                                        +47 more badges