Difficulty
Moderate
Steps
5
Time Required
15 - 30 minutes
Sections
2
- Motherboard
- 4 steps
- Directional Pad
- 1 step
Flags
0
BackPowerA Enhanced Wireless Controller
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Motherboard
- Remove the battery cover by pressing down on the lever located on the top of the cover.
- Apply pressure until it clicks out of place, and pull it off.
Remove the battery cover by pressing down on the lever located on the top of the cover.
Apply pressure until it clicks out of place, and pull it off.
1024
Step 2
- Remove all eight screws using the J0 screwdriver.
Remove all eight screws using the J0 screwdriver.
Step 3
- Insert the iFixit opening tool into the seam and gently pry the cover plate up.
- Remove the cover plate once it is loosened.
Insert the iFixit opening tool into the seam and gently pry the cover plate up.
Remove the cover plate once it is loosened.
Step 4
- Remove all three screws securing the motherboard using the J00 screwdriver.
- Remove the motherboard.
Remove all three screws securing the motherboard using the J00 screwdriver.
Remove the motherboard.
Step 5
Directional Pad
- Use the rubber tweezers to grab the center of the directional pad and pull it out by pinching its center.
Use the rubber tweezers to grab the center of the directional pad and pull it out by pinching its center.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Ayjah Montgomery
Member since: 10/10/2019
385 Reputation
4 Guides authored
Badges:
10
+7 more badges
Team
USF Tampa, Team S1-G5, Leahy Fall 2019
Member of USF Tampa, Team S1-G5, Leahy Fall 2019
USFT-LEAHY-F19S1G5
3 Members
10 Guides authored
