Powera Fusion Controller For Xbox One Buttons Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

                          20 minutes            

Sections

1

• Buttons
• 6 steps

Flags

Missing Details

Some of this guide’s details are missing. Help users by adding tools, difficulty, or time.

• BackPowerA Fusion Controller

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Buttons               

• Remove the (9) nine 9.2mm screws with a JIS #1 screwdriver.
• Remove the two bottom plastic grip covers.

Remove the (9) nine 9.2mm screws with a JIS #1 screwdriver.

Remove the two bottom plastic grip covers.

1024

Step 2

• Remove the (2) two 9.2mm screws with a JIS #1 screwdriver.
• Remove the back cover of the controller.

Remove the (2) two 9.2mm screws with a JIS #1 screwdriver.

Remove the back cover of the controller.

Step 3

• Remove the (5) five 9.2mm screws with a JIS #1 screwdriver.
• Lift the motherboard and let it hang.

Remove the (5) five 9.2mm screws with a JIS #1 screwdriver.

Lift the motherboard and let it hang.

Step 4

• Remove the (4) four 9.2mm screws that are holding the motherboard to the controller.
• Put the motherboard aside.

Remove the (4) four 9.2mm screws that are holding the motherboard to the controller.

Put the motherboard aside.

Step 5

• Remove the buttons.

Remove the buttons.

Step 6

• Go back to the motherboard, and remove the buttons’ gasket with a tweezler.

Go back to the motherboard, and remove the buttons’ gasket with a tweezler.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      6 other people completed this guide.                                             

Author

                                      with 1 other contributor 

                    Andrea                     

Member since: 09/26/2017

566 Reputation

                                      4 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges                           

Team

                       USF Tampa, Team S14-G4, Boczar Fall 2017                        

                                                  Member of USF Tampa, Team S14-G4, Boczar Fall 2017 



                    USFT-BOCZAR-F17S14G4                     


                                            4 Members                     


                                            5 Guides authored                     

Heather Jesse - May 22, 2019

Reply

Okay so what do you do if by any chance one of the links that are sawdered to the mother board for the D Pad Connection cable breaks… Then what? How would I go about fixing that????

urmum - Nov 26, 2022

Reply

is there a guide to clean the bumpers out? my RB became less consistent and i’m hoping it’s just because they’re gunked up