Difficulty

Easy

Steps

7

Time Required

Suggest a time??

Sections

3

  • Keyboard
  • 3 steps
  • Heat Shield
  • 2 steps
  • Airport Card
  • 2 steps

Flags

0

  • BackPowerBook G3 Pismo

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Keyboard
  • Turn the keyboard locking screw so that it is parallel to the space bar.
  • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.
  • Lift the keyboard out by pulling it up and away from you. Rest the keyboard, face down, on top of the track pad.

Turn the keyboard locking screw so that it is parallel to the space bar.

Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

Lift the keyboard out by pulling it up and away from you. Rest the keyboard, face down, on top of the track pad.

1024

Step 2

  • Pull the keyboard ribbon straight up from the logic board. Place the keyboard aside.
  • The connector may be tight. Gently rock the connector from side to side while pulling directly upward to free it. You can use this technique on many of the cards and cables you’ll be disconnecting.
  • Make sure you have removed the laptop battery and CD/DVD modules from the expansion bays before proceeding.

Pull the keyboard ribbon straight up from the logic board. Place the keyboard aside.

The connector may be tight. Gently rock the connector from side to side while pulling directly upward to free it. You can use this technique on many of the cards and cables you’ll be disconnecting.

Make sure you have removed the laptop battery and CD/DVD modules from the expansion bays before proceeding.

Step 3

  • Your laptop should look approximately like this.

Your laptop should look approximately like this.

Step 4

              Heat Shield
  • Remove the two silver Phillips #1 screws that attach the heat shield to the internal metal framework.
  • Lift the heat shield up and pull it toward you.

Remove the two silver Phillips #1 screws that attach the heat shield to the internal metal framework.

Lift the heat shield up and pull it toward you.

Step 5

Step 6

              Airport Card
  • Skip this step if your computer does not have an Airport card installed.
  • Firmly grasp the plastic tab attached to the Airport card and pull up and then to the right.
  • The Airport card is still attached to the antenna cable, so don’t just yank it out of the slot.

Skip this step if your computer does not have an Airport card installed.

Firmly grasp the plastic tab attached to the Airport card and pull up and then to the right.

The Airport card is still attached to the antenna cable, so don’t just yank it out of the slot.

Step 7

  • Disconnect the antenna cable from the Airport card.

Disconnect the antenna cable from the Airport card.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      18 other people completed this guide.

Attached Documents

  • G3-Pismo-Screw-Guide.pdf
  • PDF - 415.32 kb
  • View

G3-Pismo-Screw-Guide.pdf

PDF - 415.32 kb

Author

                                      with 2 other contributors 


                    iRobot

Member since: 09/24/2009

1 Reputation

                                      646 Guides authored                  



                       Badges:
                       36





                                                        +33 more badges