Featured

Featured Guide

Difficulty

Easy

Steps

5

Time Required

Suggest a time??

Sections

3

  • Battery
  • 1 step
  • Keyboard
  • 3 steps
  • RAM
  • 1 step

Flags

1

This guide has been found to be exceptionally cool by the iFixit staff.

  • BackPowerBook G4 Titanium DVI

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Locate the battery release tab on the underside of the G4.
  • Slide the battery release tab to the left and lift the battery out of the computer.

Locate the battery release tab on the underside of the G4.

Slide the battery release tab to the left and lift the battery out of the computer.

1024

Step 2

              Keyboard
  • Turn the keyboard locking screw located in the middle of the keyboard so that it is parallel to the space bar. A half turn from parallel to parallel will unlock it. Another half turn will lock it again.
  • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

Turn the keyboard locking screw located in the middle of the keyboard so that it is parallel to the space bar. A half turn from parallel to parallel will unlock it. Another half turn will lock it again.

Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

Step 3

  • Rest the keyboard face down on the trackpad area.
  • Disconnect the keyboard connector from the logic board.

Rest the keyboard face down on the trackpad area.

Disconnect the keyboard connector from the logic board.

Step 4

  • Your laptop should look approximately like this.

Your laptop should look approximately like this.

Step 5

              RAM
  • Release the tabs on each side of the RAM chip at the same time. These tabs lock the chip in place and releasing them will cause the chip to “pop” up.
  • Pull the RAM chip out.
  • Repeat this process if a second RAM chip is installed.

Release the tabs on each side of the RAM chip at the same time. These tabs lock the chip in place and releasing them will cause the chip to “pop” up.

Pull the RAM chip out.

Repeat this process if a second RAM chip is installed.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      24 other people completed this guide.

Attached Documents

  • G4-Ti-DVI-Screw-Guide.pdf
  • PDF - 416.04 kb
  • View

G4-Ti-DVI-Screw-Guide.pdf

PDF - 416.04 kb

Author

                                      with 3 other contributors 


                    iRobot

Member since: 09/24/2009

1 Reputation

                                      646 Guides authored                  



                       Badges:
                       36





                                                        +33 more badges