Powerex Mh C980 Disassembly Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 minutes

Sections

Powerex MH-C980 Disassembly
3 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

BackPowerex MH-C980
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

Step 1

              Removing the bottom cover

Remove the 4 adhesive rubber feet. Then remove the 4 screws.

Remove the 4 adhesive rubber feet. Then remove the 4 screws.

1024

Step 2

              Take bottom plastic off

Take the bottom plastic cover off. It just comes off, no tabs or any glue. Remove the fan cable from the main board.

Take the bottom plastic cover off. It just comes off, no tabs or any glue. Remove the fan cable from the main board.

Step 3

              Fan removal

Remove fan by removing the adhesive tape from the fan cable. Then remove the 4-rubber feet stickers holding the fan into the bottom case. Then pull the fan out. Fan PN is FD-4007HH12C. Made by Titan.
Fan measures 40x40x7mm. Takes 12V at 0.18A. 2.16 Watts. RPM of 6500. 7.68 CFM. 0.11 INCH-H2O. <28.7 NOISE (DBA).
There is not room for a 10mm tall fan due to the electrical contacts that come out of the bottom of the board. The only other fan that might work is a 6mm tall fan from Orion Fans (PN OD4006-12HSS)
Charger seems to work just fine without the fan installed, but then the components and your batteries may get hotter than the OEM intended. (fan was too loud for me).

Remove fan by removing the adhesive tape from the fan cable. Then remove the 4-rubber feet stickers holding the fan into the bottom case. Then pull the fan out. Fan PN is FD-4007HH12C. Made by Titan.

Fan measures 40x40x7mm. Takes 12V at 0.18A. 2.16 Watts. RPM of 6500. 7.68 CFM. 0.11 INCH-H2O. <28.7 NOISE (DBA).

There is not room for a 10mm tall fan due to the electrical contacts that come out of the bottom of the board. The only other fan that might work is a 6mm tall fan from Orion Fans (PN OD4006-12HSS)

Charger seems to work just fine without the fan installed, but then the components and your batteries may get hotter than the OEM intended. (fan was too loud for me).

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                    Daniel Grohol

Member since: 04/24/2016

211 Reputation

                                      2 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Member-Contributed Guide#

Introduction#

#

#

#

#

#

Member-Contributed Guide

Introduction