Powerlead Puto Pld003 Back Buttons Replacement Repair Guide

Difficulty

Moderate

Steps

9

Time Required

                          15 minutes            

Sections

2

• Side Panel
• 4 steps
• Back Buttons
• 5 steps

Flags

1

Bullets!

Better coordination with markups and the color/type of bullets will help make this guide more clear!

• BackPowerLead Puto PLD003

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Side Panel               

• Slide the battery eject button open to release the battery door.

Slide the battery eject button open to release the battery door.

1024

Step 2

• With the battery door open, carefully remove all four 5 mm Phillips #1 screws.

With the battery door open, carefully remove all four 5 mm Phillips #1 screws.

Step 3

• Rotate the camera so that the underside is facing up.
• Remove the four 5 mm Phillips #1 screws.

Rotate the camera so that the underside is facing up.

Remove the four 5 mm Phillips #1 screws.

Step 4

• Place the camera on a flat surface, with its underside facing you.
• Gently pull up on the side panel to remove it from the camera.

Place the camera on a flat surface, with its underside facing you.

Gently pull up on the side panel to remove it from the camera.

Step 5

              Back Buttons               

• Remove the three 4 mm Phillips #1 screws holding the weight.
• Remove the weight.

Remove the three 4 mm Phillips #1 screws holding the weight.

Remove the weight.

Step 6

• Remove the two 4 mm Phillips #1 screws holding the back panel in place.

Remove the two 4 mm Phillips #1 screws holding the back panel in place.

Step 7

• Apply pressure to the back panel, away from the camera to remove.

Apply pressure to the back panel, away from the camera to remove.

Step 8

• Place the back panel so the buttons are facing down and the circuit board is facing up.
• Remove the three 4 mm Phillips #1 screws holding the circuit board in place.

Place the back panel so the buttons are facing down and the circuit board is facing up.

Remove the three 4 mm Phillips #1 screws holding the circuit board in place.

Step 9

• Set aside the circuit board.
• These nubs are what is currently holding the buttons in place.
• Carefully apply pressure and remove the set of buttons from the nubs.

Set aside the circuit board.

These nubs are what is currently holding the buttons in place.

Carefully apply pressure and remove the set of buttons from the nubs.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 1 other contributor 

                    Justin Tew                     

Member since: 03/31/2016

767 Reputation

                                      7 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges                           

Team

                       Eastern Washington University, Team 1-2, Giguere Spring 2016                        

                                                  Member of Eastern Washington University, Team 1-2, Giguere Spring 2016 



                    EWU-GIGUERE-S16S1G2                     


                                            4 Members                     


                                            7 Guides authored