Difficulty

Moderate

Steps

10

Time Required

                          30 minutes

Sections

2

  • Side Panel
  • 4 steps
  • Screen
  • 6 steps

Flags

0

  • BackPowerLead Puto PLD003

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Side Panel
  • Slide the battery eject button open to release the battery door.

Slide the battery eject button open to release the battery door.

1024

Step 2

  • With the battery door open, carefully remove all four 5 mm Phillips #1 screws.

With the battery door open, carefully remove all four 5 mm Phillips #1 screws.

Step 3

  • Rotate the camera so that the underside is facing up.
  • Remove the four 5 mm Phillips #1 screws.

Rotate the camera so that the underside is facing up.

Remove the four 5 mm Phillips #1 screws.

Step 4

  • Place the camera on a flat surface, with its underside facing you.
  • Gently pull up on the side panel to remove it from the camera.

Place the camera on a flat surface, with its underside facing you.

Gently pull up on the side panel to remove it from the camera.

Step 5

              Screen
  • Remove the three 4 mm Phillips #1 screws holding the weight.
  • Remove the weight.

Remove the three 4 mm Phillips #1 screws holding the weight.

Remove the weight.

Step 6

  • Remove the two 4 mm Phillips #1 screws holding the back panel in place.

Remove the two 4 mm Phillips #1 screws holding the back panel in place.

Step 7

  • Remove the back panel away from the camera by applying pressure to it.

Remove the back panel away from the camera by applying pressure to it.

Step 8

  • Set aside back panel for now.
  • Remove the final 4 mm Phillips #1 screw holding the screen in place. It is very small and hard to see.

Set aside back panel for now.

Remove the final 4 mm Phillips #1 screw holding the screen in place. It is very small and hard to see.

Step 9

  • Carefully apply pressure, away from the camera, to the screen to detach it from the body.
  • The white cord should still be connected to the body.

Carefully apply pressure, away from the camera, to the screen to detach it from the body.

The white cord should still be connected to the body.

Step 10

  • Lift the black clip upward.
  • With the clip up, pull the white cord to the left. This will detach the screen from the body.

Lift the black clip upward.

With the clip up, pull the white cord to the left. This will detach the screen from the body.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Justin Tew

Member since: 03/31/2016

767 Reputation

                                      7 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges

Team

                       Eastern Washington University, Team 1-2, Giguere Spring 2016                        

                                                  Member of Eastern Washington University, Team 1-2, Giguere Spring 2016 



                    EWU-GIGUERE-S16S1G2                     


                                            4 Members                     


                                            7 Guides authored