Difficulty
Moderate
Steps
5
Time Required
5 minutes
Sections
2
- Side Panel
- 4 steps
- Tripod Clip
- 1 step
Flags
0
BackPowerLead Puto PLD003
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Side Panel
- Slide the battery eject button open to release the battery door.
Slide the battery eject button open to release the battery door.
1024
Step 2
- With the battery door open, carefully remove all four 5 mm Phillips #1 screws.
With the battery door open, carefully remove all four 5 mm Phillips #1 screws.
Step 3
- Rotate the camera so that the underside is facing up.
- Remove the four 5 mm Phillips #1 screws.
Rotate the camera so that the underside is facing up.
Remove the four 5 mm Phillips #1 screws.
Step 4
- Place the camera on a flat surface, with its underside facing you.
- Gently pull up on the side panel to remove it from the camera.
Place the camera on a flat surface, with its underside facing you.
Gently pull up on the side panel to remove it from the camera.
Step 5
Tripod Clip
- Apply pressure upwards to remove the tripod clip.
Apply pressure upwards to remove the tripod clip.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
Justin Tew
Member since: 03/31/2016
767 Reputation
7 Guides authored
Badges:
13
+10 more badges
Team
Eastern Washington University, Team 1-2, Giguere Spring 2016
Member of Eastern Washington University, Team 1-2, Giguere Spring 2016
EWU-GIGUERE-S16S1G2
4 Members
7 Guides authored
