Difficulty
Moderate
Steps
9
Time Required
30 minutes
Sections
1
- Voltage Capacitor
- 9 steps
Flags
0
BackPrem Air Circulator Fan 18"
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Voltage Capacitor
- Open up the cap of the ventilator by turning the clips on the side outwards.
- Remove the screw on the bottom.
Open up the cap of the ventilator by turning the clips on the side outwards.
Remove the screw on the bottom.
1024
Step 2
- Remove the propellor by turning loose the knob and pulling out the propellor.
Remove the propellor by turning loose the knob and pulling out the propellor.
Step 3
- Identify the screws to remove.
- Pull back the plastic back.
Identify the screws to remove.
Pull back the plastic back.
Step 4
- Remove the screw on the back of the body to disasemble the Voltage Capacitor from the body.
Remove the screw on the back of the body to disasemble the Voltage Capacitor from the body.
Step 5
- Disconnecting the wires.
- Cut the tie-wraps keeping the wires together.
- Remove the white caps from the wires between the black and yellow wires.
Disconnecting the wires.
Cut the tie-wraps keeping the wires together.
Remove the white caps from the wires between the black and yellow wires.
Step 6
- Remove the regulator.
Remove the regulator.
Step 7
- Connect the new Voltage Capacitor wires with the wires where the old capacitor came from.
- Make sure the wire tips are integrated.
- Put back the protection caps and push them tight. (you could also use new ones).
Connect the new Voltage Capacitor wires with the wires where the old capacitor came from.
Make sure the wire tips are integrated.
Put back the protection caps and push them tight. (you could also use new ones).
Step 8
- Assamble the regulator.
- Place the new Voltage Capacitor at the right place and screw back the screw to hold it there.
Assamble the regulator.
Place the new Voltage Capacitor at the right place and screw back the screw to hold it there.
Step 9
- Reverse the disassembly steps 1 to 3 to put the product back together.
Reverse the disassembly steps 1 to 3 to put the product back together.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Romy Zwetsloot
Member since: 03/08/2017
101 Reputation
1 Guide authored
Badges:
2
Team
Delft University of Technology, Team S1-G16, Flipsen Spring 2017
Member of Delft University of Technology, Team S1-G16, Flipsen Spring 2017
TUD-FLIPSEN-S17S1G16
3 Members
1 Guide authored
