Difficulty

Easy

Steps

6

Time Required

                          5 minutes

Sections

1

  • Wire
  • 6 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackWire

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Wire
  • Locate QCPN#10669 which is a black hookup wire.

Locate QCPN#10669 which is a black hookup wire.

1024

Step 2

  • Measure out a 10cm length of wire.
  • Use a pair of flash cutters to carefully cut through the wire.
  • Caution: the wire must be no longer than 10.5cm and no shorter than 9.5cm in length.

Measure out a 10cm length of wire.

Use a pair of flash cutters to carefully cut through the wire.

Caution: the wire must be no longer than 10.5cm and no shorter than 9.5cm in length.

Step 3

  • Your wire should look like this now. #testedit

Your wire should look like this now. #testedit

Step 4

  • Measure 20mm from either end of the wire.
  • With the flash cutters remove the instulation that is covering the wire.
  • Be careful not to cut to deep because you will damage the wire strands inside.

Measure 20mm from either end of the wire.

With the flash cutters remove the instulation that is covering the wire.

Be careful not to cut to deep because you will damage the wire strands inside.

Step 5

  • Measure 10mm from the other side of the wire.
  • Remove the insulation from the wire with a pair of flash cutters.

Measure 10mm from the other side of the wire.

Remove the insulation from the wire with a pair of flash cutters.

Step 6

  • Your finished wire should now look like this.
  • Remember to twist of the ends of the wire with your fingers so that the wire strands are not loose.

Your finished wire should now look like this.

Remember to twist of the ends of the wire with your fingers so that the wire strands are not loose.

You are finished.

Cancel: I did not complete this guide.

                                                                                      6 other people completed this guide.

Author

                                      with 3 other contributors 


                    Russell Frampton

Member since: 07/30/2013

356 Reputation

                                      1 Guide authored                  



                       Badges:
                       4







                                                        +1 more badge