Difficulty

Moderate

Steps

5

Time Required

                          20 - 30 minutes

Sections

2

  • Shell
  • 4 steps
  • Toaster Solenoid
  • 1 step

Flags

0

  • BackProfessional Series PS77401

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Shell
  • Make sure that the toaster is unplugged before attempting any sort of disassembly!

Make sure that the toaster is unplugged before attempting any sort of disassembly!

1024

Step 2

  • Grip the black plastic lever nub firmly and carefully remove it from the metal lever. Use one hand to hold the toaster in place while you pull the lever nub with the other.
  • If this is the first time detaching this piece, it will take some effort to remove. Be careful as pulling too hard can cause damage to the inner lever mechanism.

Grip the black plastic lever nub firmly and carefully remove it from the metal lever. Use one hand to hold the toaster in place while you pull the lever nub with the other.

If this is the first time detaching this piece, it will take some effort to remove. Be careful as pulling too hard can cause damage to the inner lever mechanism.

Step 3

  • Flipping the toaster upside down, use a T7 Torx Screwdriver to remove the four 10mm screws that keep the outer shell attached.
  • Flip the toaster back over and slide off the shell making sure to slip the toaster lever (now without the black plastic nub) through the lever opening in the shell.
  • The outer shell should now only be connected by its internal wiring.

Flipping the toaster upside down, use a T7 Torx Screwdriver to remove the four 10mm screws that keep the outer shell attached.

Flip the toaster back over and slide off the shell making sure to slip the toaster lever (now without the black plastic nub) through the lever opening in the shell.

The outer shell should now only be connected by its internal wiring.

Step 4

  • Locate and remove the two 8mm screws that attach the circuit board (located inside of the shell) from the shell itself using the Phillips #2 screwdriver.
  • The shell should now be completely separated from the rest of the toaster.

Locate and remove the two 8mm screws that attach the circuit board (located inside of the shell) from the shell itself using the Phillips #2 screwdriver.

The shell should now be completely separated from the rest of the toaster.

Step 5

              Toaster Solenoid
  • Locate the metal knob protruding from the removed circuit board.
  • Remove the 10mm nut with an equally sized wrench and replace the now removable solenoid.

Locate the metal knob protruding from the removed circuit board.

Remove the 10mm nut with an equally sized wrench and replace the now removable solenoid.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Jacob M Bassetti

Member since: 01/24/2014

113 Reputation

                                      1 Guide authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       Cal Poly, Team 10-36, Maness Winter 2014                        

                                                  Member of Cal Poly, Team 10-36, Maness Winter 2014 



                    CPSU-MANESS-W14S10G36                     


                                            4 Members                     


                                            5 Guides authored

Stewart - Nov 16, 2020

Reply

That’s not a solenoid, that’s a potentiometer. And it’s probably soldered in so you would need to desolder it and solder in a new one, if you could find the part.