Difficulty

Moderate

Steps

7

Time Required

Suggest a time??

Sections

1

  • Camera
  • 7 steps

Flags

Missing Details

Some of this guide’s details are missing. Help users by adding tools, difficulty, or time.

  • BackProntoTec Axius

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Camera
  • Make sure the device is completely turned off before you begging taking it apart to avoid electrocution risks.
  • Place the tablet face-up on a flat table.

Make sure the device is completely turned off before you begging taking it apart to avoid electrocution risks.

Place the tablet face-up on a flat table.

1024

Step 2

  • Starting near the headphone port, fit the flat end of the spudger in between the screen and back case.
  • Pry the back case from the screen around each point on the device to release the clips securing the case halves to each other.

Starting near the headphone port, fit the flat end of the spudger in between the screen and back case.

Pry the back case from the screen around each point on the device to release the clips securing the case halves to each other.

Step 3

  • Gently remove the back case of the device and lay it in a flat surface as shown in the photo.
  • Make sure not to sever the wires (red and black) connected to the speaker that is located in the back case.

Gently remove the back case of the device and lay it in a flat surface as shown in the photo.

Make sure not to sever the wires (red and black) connected to the speaker that is located in the back case.

Step 4

  • Remove only the yellow tape that touches the battery.
  • Be careful not to cut or damage the wires (red and black) that are under the yellow tape.'

Remove only the yellow tape that touches the battery.

Be careful not to cut or damage the wires (red and black) that are under the yellow tape.'

Step 5

  • Use the flat end of the spudger to gently pry the top left corner battery from the back of the screen in order to access the camera.

Use the flat end of the spudger to gently pry the top left corner battery from the back of the screen in order to access the camera.

Step 6

  • Use the spudger to lift the black clamp as shown in the photo to disconnect the camera from the motherboard.

Use the spudger to lift the black clamp as shown in the photo to disconnect the camera from the motherboard.

Step 7

  • Disconet the camera from the motherboard.
  • Pull the camera from the back of the screen.

Disconet the camera from the motherboard.

Pull the camera from the back of the screen.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 5 other contributors 


                    Antonio Irons

Member since: 10/20/2016

441 Reputation

                                      4 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       UMass Dartmouth, Team 5-3, Martin Fall 2016                        

                                                  Member of UMass Dartmouth, Team 5-3, Martin Fall 2016 



                    UMASSD-MARTIN-F16S5G3                     


                                            3 Members                     


                                            10 Guides authored