Difficulty
Moderate
Steps
10
Time Required
Suggest a time??
Sections
1
- Screen
- 10 steps
Flags
Incorrect Tools
Help make this guide better by using the correct tools in images and/or text.
BackProntoTec Axius
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Screen
- Make sure the device is completely turned off before you begin taking it apart to avoid risk of electrocution.
- Place the tablet face-up on a flat table
Make sure the device is completely turned off before you begin taking it apart to avoid risk of electrocution.
Place the tablet face-up on a flat table
1024
Step 2
- Starting near the headphone port, fit the flat end of the spudger in between the screen and back case.
- Pry the back case from the screen around each point on the device to release the clips securing the case halves to each other.
Starting near the headphone port, fit the flat end of the spudger in between the screen and back case.
Pry the back case from the screen around each point on the device to release the clips securing the case halves to each other.
Step 3
- Gently remove the back case of the device and lay it in a flat surface as shown in the photo.
- Make sure not to sever the wires (red and black) connected to the speaker that is located in the back case.
Gently remove the back case of the device and lay it in a flat surface as shown in the photo.
Make sure not to sever the wires (red and black) connected to the speaker that is located in the back case.
Step 4
- Remove all of the yellow tape that is on the device with the spudger.
- Be careful not to cut any wires that are under the tapes.
Remove all of the yellow tape that is on the device with the spudger.
Be careful not to cut any wires that are under the tapes.
Step 5
- Use the flat end of the spudger to gently pry the battery from the back of the screen.
Use the flat end of the spudger to gently pry the battery from the back of the screen.
Step 6
- Use a spudger to lift all the ribbon cable clamps
- Detach all three ribbon cables from the clamps
Use a spudger to lift all the ribbon cable clamps
Detach all three ribbon cables from the clamps
Step 7
- Using a Phillips screwdriver (PH00), unscrew the motherboard from the device
Using a Phillips screwdriver (PH00), unscrew the motherboard from the device
Step 8
- Use the flat end of the metal spudger to remove the battery from the back of the screen of the device.
- Avoid using metal when prying off the battery. For serious prying power, try using the heavy-duty plastic spudger.
Use the flat end of the metal spudger to remove the battery from the back of the screen of the device.
Avoid using metal when prying off the battery. For serious prying power, try using the heavy-duty plastic spudger.
Step 9
- Remove the orange tab from the back of the screen as shown in the picture
Remove the orange tab from the back of the screen as shown in the picture
Step 10
- Use the flat end of the metal spudger to unclip and remove the screen from the casing.
Use the flat end of the metal spudger to unclip and remove the screen from the casing.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 5 other contributors
Antonio Irons
Member since: 10/20/2016
441 Reputation
4 Guides authored
Badges:
11
+8 more badges
Team
UMass Dartmouth, Team 5-3, Martin Fall 2016
Member of UMass Dartmouth, Team 5-3, Martin Fall 2016
UMASSD-MARTIN-F16S5G3
3 Members
10 Guides authored
