Difficulty

Difficult

Steps

5

Time Required

                          5 minutes

Sections

2

  • Open Device
  • 2 steps
  • Battery
  • 3 steps

Flags

0

  • BackProScan PLT7050

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Open Device
  • Make sure device is unplugged and turned off while working on the device.
  • Remove 2 Phillips head, 4.3 mm screws from the bottom side of the tablet with a PH00 screwdriver.

Make sure device is unplugged and turned off while working on the device.

Remove 2 Phillips head, 4.3 mm screws from the bottom side of the tablet with a PH00 screwdriver.

1024

Step 2

  • Use the plastic opening tools to pry the back of the tablet open.
  • You may need to slide the tool along the sides of the device to get it to open. You might hear some popping noises, it is okay.
  • May be helpful if you start by the microSD slot.

Use the plastic opening tools to pry the back of the tablet open.

You may need to slide the tool along the sides of the device to get it to open. You might hear some popping noises, it is okay.

May be helpful if you start by the microSD slot.

Step 3

              Battery
  • Use the soldering tool to remove the wires from the motherboard. (Black and Red)
  • The soldering tool is hot.
  • Take note of where the wires are located.

Use the soldering tool to remove the wires from the motherboard. (Black and Red)

The soldering tool is hot.

Take note of where the wires are located.

Step 4

  • Remove the black tape from the battery.
  • Remove the three pieces of yellow tape from the battery.

Remove the black tape from the battery.

Remove the three pieces of yellow tape from the battery.

Step 5

  • Use the plastic opening tool to pry the battery from the device as it is attached by an adhesive.
  • Do not proceed if corrosion and/or swelling of the battery is visible.

Use the plastic opening tool to pry the battery from the device as it is attached by an adhesive.

Do not proceed if corrosion and/or swelling of the battery is visible.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.

Author

                                      with 4 other contributors 


                    Jazmine Jackson

Member since: 01/19/2017

284 Reputation

                                      2 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Eastern Washington University, Team 1-4, Mathisen Winter 2017                        

                                                  Member of Eastern Washington University, Team 1-4, Mathisen Winter 2017 



                    EWU-MATHISEN-W17S1G4                     


                                            5 Members                     


                                            12 Guides authored