Difficulty
Difficult
Steps
4
Time Required
4 minutes
Sections
2
- Open Device
- 2 steps
- Speaker
- 2 steps
Flags
0
BackProScan PLT7050
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Open Device
- Make sure device is unplugged and turned off while working on the device.
- Remove 2 Phillips head, 4.3 mm screws from the bottom side of the tablet with a PH00 screwdriver.
Make sure device is unplugged and turned off while working on the device.
Remove 2 Phillips head, 4.3 mm screws from the bottom side of the tablet with a PH00 screwdriver.
1024
Step 2
- Use the plastic opening tools to pry the back of the tablet open.
- You may need to slide the tool along the sides of the device to get it to open. You might hear some popping noises, it is okay.
- May be helpful if you start by the microSD slot.
Use the plastic opening tools to pry the back of the tablet open.
You may need to slide the tool along the sides of the device to get it to open. You might hear some popping noises, it is okay.
May be helpful if you start by the microSD slot.
Step 3
Speaker
- Remove the yellow tape.
Remove the yellow tape.
Step 4
- Use the soldering tool to remove the two speaker wires from the mother board.
- Take note of where the wires are located.
- Soldering tool will get hot.
Use the soldering tool to remove the two speaker wires from the mother board.
Take note of where the wires are located.
Soldering tool will get hot.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Jazmine Jackson
Member since: 01/19/2017
284 Reputation
2 Guides authored
Badges:
8
+5 more badges
Team
Eastern Washington University, Team 1-4, Mathisen Winter 2017
Member of Eastern Washington University, Team 1-4, Mathisen Winter 2017
EWU-MATHISEN-W17S1G4
5 Members
12 Guides authored
