Proscan Plt7223G Screen Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 minutes

Sections

Screen
6 steps

Flags

BackProScan PLT7223G
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Screen

Remove both 4 mm screws on the top of the tablet with a PH00 screw driver.

Remove both 4 mm screws on the top of the tablet with a PH00 screw driver.

1024

Step 2

Use the blue plastic opening tool to pry open the tablet.
You will hear popping sounds. That’s okay.
Be careful when using the blue plastic opening tool on the side of the device near the speakers, as there is a wire here that connects the speakers to the motherboard.

Use the blue plastic opening tool to pry open the tablet.

You will hear popping sounds. That’s okay.

Be careful when using the blue plastic opening tool on the side of the device near the speakers, as there is a wire here that connects the speakers to the motherboard.

Step 3

Remove three 4 mm screws from the motherboard.

Remove three 4 mm screws from the motherboard.

Step 4

Insert a spudger under the black tape that connects the silver wire to the interior of the front panel
Pull back the black tape with the spudger until it can be lifted up with your fingers.
Use your fingers to grab and lift the remainder of the black tape from device panel.

Insert a spudger under the black tape that connects the silver wire to the interior of the front panel

Pull back the black tape with the spudger until it can be lifted up with your fingers.

Use your fingers to grab and lift the remainder of the black tape from device panel.

Step 5

Use a plastic opening tool to push back the ZIF connector to release the ribbon wire on the motherboard.

Use a plastic opening tool to push back the ZIF connector to release the ribbon wire on the motherboard.

Step 6

Insert an opening tool underneath the silver base of the internal device element.
Use the opening tool to pry the element out of the case that holds the screen.
You will need to release a number of clips in order to remove the screen.
Be careful not to damage the motherboard or battery as you go.

Insert an opening tool underneath the silver base of the internal device element.

Use the opening tool to pry the element out of the case that holds the screen.

You will need to release a number of clips in order to remove the screen.

Be careful not to damage the motherboard or battery as you go.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      6 other people completed this guide.

Author

                                      with 4 other contributors

                    Nathaniel Girard

Member since: 01/12/2016

287 Reputation

                                      2 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Eastern Washington University, Team 1-4, Rowley Winter 2016                        

                                                  Member of Eastern Washington University, Team 1-4, Rowley Winter 2016 



                    EWU-ROWLEY-W16S1G4                     


                                            4 Members                     


                                            10 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team