Difficulty

Moderate

Steps

10

Time Required

                          50 minutes - 1 hour

Sections

2

  • Drone Battery Pack
  • 3 steps
  • Camera
  • 7 steps

Flags

0

  • BackProtocol Dronium III AP

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Drone Battery Pack
  • Ensure the drone is powered off.
  • Press in and lift battery compartment cover.
  • A soft pry tool may be used for easier access.

Ensure the drone is powered off.

Press in and lift battery compartment cover.

A soft pry tool may be used for easier access.

1024

Step 2

  • Remove battery pack from body of drone.

Remove battery pack from body of drone.

Step 3

  • Disconnect white connectors between the battery pack and drone.

Disconnect white connectors between the battery pack and drone.

Step 4

              Camera
  • Remove the eight (8) 5mm screws attaching the motor arms to the body using a JIS #00 screwdriver.

Remove the eight (8) 5mm screws attaching the motor arms to the body using a JIS #00 screwdriver.

Step 5

  • Remove the six (6) 5mm screws attaching the Body Cover to the Body of the drone using a JIS #00 screwdriver.
  • Remove the Body Cover.

Remove the six (6) 5mm screws attaching the Body Cover to the Body of the drone using a JIS #00 screwdriver.

Remove the Body Cover.

Step 6

  • Remove the two (2) 5mm screws attaching the Motherboard to the body of the drone using a JIS #00 screwdriver.
  • Lift the Motherboard off the mounting position.
  • Do not pull hard on the Motherboard as solder connections are fragile.

Remove the two (2) 5mm screws attaching the Motherboard to the body of the drone using a JIS #00 screwdriver.

Lift the Motherboard off the mounting position.

Do not pull hard on the Motherboard as solder connections are fragile.

Step 7

  • Remove the tape covering the camera with the tweezers.

Remove the tape covering the camera with the tweezers.

Step 8

  • Remove the plastic holding the ribbon cable connector with the tweezers.
  • Be careful with the ribbon cable, it is easy to damage.

Remove the plastic holding the ribbon cable connector with the tweezers.

Be careful with the ribbon cable, it is easy to damage.

Step 9

  • Move the ribbon cable out of the way with the Spuger.

Move the ribbon cable out of the way with the Spuger.

Step 10

  • Remove the camera by gently prying it out of the bracket with the spudger.

Remove the camera by gently prying it out of the bracket with the spudger.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Steven Mooers

Member since: 10/18/2017

401 Reputation

                                      4 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       UW Tacoma, Team S1-G1, Rose Fall 2017                        

                                                  Member of UW Tacoma, Team S1-G1, Rose Fall 2017 



                    UWT-ROSE-F17S1G1                     


                                            4 Members                     


                                            4 Guides authored