Protocol Dronium Iii Ap Light Bulb Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          20 minutes

Sections

Drone Battery Pack
3 steps
L.E.D. Bulb(s)
4 steps

Flags

BackProtocol Dronium III AP
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Drone Battery Pack

Ensure the drone is powered off.
Press in and lift battery compartment cover.
A soft pry tool may be used for easier access.

Ensure the drone is powered off.

Press in and lift battery compartment cover.

A soft pry tool may be used for easier access.

1024

Step 2

Remove battery pack from body of drone.

Remove battery pack from body of drone.

Step 3

Disconnect white connectors between the battery pack and drone.

Disconnect white connectors between the battery pack and drone.

Step 4

              L.E.D. Bulb(s)

Remove the eight (8) 5mm Philips screws attaching the motor arms to the body using a Philips J00 screwdriver.

Remove the eight (8) 5mm Philips screws attaching the motor arms to the body using a Philips J00 screwdriver.

Step 5

Remove the six (6) 5mm Philips screws attaching the Body Cover to the Body of the drone using a Philips J00 screwdriver.
Remove the Body Cover.

Remove the six (6) 5mm Philips screws attaching the Body Cover to the Body of the drone using a Philips J00 screwdriver.

Remove the Body Cover.

Step 6

Remove the two (2) 5mm Philips screws attaching the Motherboard to the body of the drone using a Philips J00 screwdriver.
Lift the Motherboard off the mounting position.
Do not pull hard on the Motherboard as solder connections are fragile.

Remove the two (2) 5mm Philips screws attaching the Motherboard to the body of the drone using a Philips J00 screwdriver.

Lift the Motherboard off the mounting position.

Do not pull hard on the Motherboard as solder connections are fragile.

Step 7

This step contains a tool that can present a potential burn hazard.
Prepare and warm up a soldering iron.
Position Motherboard so that the L.E.D. bulb solder joints are accessible.
Use the soldering iron to melt the solder joints.
For more detailed instructions on how to solder, visit out How to Solder and Desolder Connections guide.
Remove the L.E.D. bulb from the Motherboard

This step contains a tool that can present a potential burn hazard.

Prepare and warm up a soldering iron.

Position Motherboard so that the L.E.D. bulb solder joints are accessible.

Use the soldering iron to melt the solder joints.

For more detailed instructions on how to solder, visit out How to Solder and Desolder Connections guide.

Remove the L.E.D. bulb from the Motherboard

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    Steven Mooers

Member since: 10/18/2017

401 Reputation

                                      4 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       UW Tacoma, Team S1-G1, Rose Fall 2017                        

                                                  Member of UW Tacoma, Team S1-G1, Rose Fall 2017 



                    UWT-ROSE-F17S1G1                     


                                            4 Members                     


                                            4 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team