Difficulty
Moderate
Steps
3
Time Required
15 minutes
Sections
1
- Trim Rocker Switch
- 3 steps
Flags
0
BackProtocol Dronium III AP
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Trim Rocker Switch
- Remove the four (4) 8.5mm screws from the body of the remote using a JIS #1 screwdriver.
- Remove the two (2) 4mm screws from the handle using a JIS #1 screwdriver.
- Open remote body lifting back a full 180 degrees from face.
Remove the four (4) 8.5mm screws from the body of the remote using a JIS #1 screwdriver.
Remove the two (2) 4mm screws from the handle using a JIS #1 screwdriver.
Open remote body lifting back a full 180 degrees from face.
1024
Step 2
- Remove the four (4) 6mm screws attaching the motherboard to body of the controller using a JIS #1 screwdriver
- Gently lift the motherboard backwards.
Remove the four (4) 6mm screws attaching the motherboard to body of the controller using a JIS #1 screwdriver
Gently lift the motherboard backwards.
Step 3
- Remove the trim rocker switch from the controller.
Remove the trim rocker switch from the controller.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Steven Mooers
Member since: 10/18/2017
401 Reputation
4 Guides authored
Badges:
4
+1 more badge
Team
UW Tacoma, Team S1-G1, Rose Fall 2017
Member of UW Tacoma, Team S1-G1, Rose Fall 2017
UWT-ROSE-F17S1G1
4 Members
4 Guides authored
