Difficulty
Moderate
Steps
4
Time Required
10 - 20 minutes
Sections
1
- Landing Gear
- 4 steps
Flags
0
BackProtocol Dronium One
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Landing Gear
- Remove the eight 5.2mm screws located on the drone base using a Phillips 00 screwdriver with a thin end.
Remove the eight 5.2mm screws located on the drone base using a Phillips 00 screwdriver with a thin end.
1024
Step 2
- Once all of the screws are off, lift off the top of the drone.
Once all of the screws are off, lift off the top of the drone.
Step 3
- Remove the two 5.2mm screws holding the landing gear in place using a Phillips 00 screwdriver and an extension if needed.
Remove the two 5.2mm screws holding the landing gear in place using a Phillips 00 screwdriver and an extension if needed.
Step 4
- Once the inside screws are removed, carefully pull off the one of the landing gear legs. Repeat this step for the other leg.
Once the inside screws are removed, carefully pull off the one of the landing gear legs. Repeat this step for the other leg.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Ameth Ramos
Member since: 02/20/2017
537 Reputation
5 Guides authored
Badges:
10
+7 more badges
Team
USF Tampa, Team S2-G5, Sullivan Spring 2017
Member of USF Tampa, Team S2-G5, Sullivan Spring 2017
USFT-SULLIVAN-S17S2G5
4 Members
5 Guides authored
