Protocol Galileo Stealth Battery Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          2 minutes

Sections

Battery
4 steps

Flags

BackProtocol Galileo Stealth
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

Step 1

              Battery

Locate the door to the battery compartment on the underside of the drone.

Locate the door to the battery compartment on the underside of the drone.

1024

Step 2

Open the door to the battery compartment by pressing in the clip on the door and carefully lifting until the door is fully open.

Open the door to the battery compartment by pressing in the clip on the door and carefully lifting until the door is fully open.

Step 3

First pull out the wires located to the side of the battery.
Carefully remove the battery from the battery compartment
The battery can be a bit difficult to remove, but if the wires are held firmly to the battery, the battery will eventually come out by lightly pulling on the battery and wires simultaneously.
The small black and white wire with the white plug will not be connected to the drone, just be sure the plug does not get stuck in the battery compartment and damaged while removing the battery. This is rarely an issue.

First pull out the wires located to the side of the battery.

Carefully remove the battery from the battery compartment

The battery can be a bit difficult to remove, but if the wires are held firmly to the battery, the battery will eventually come out by lightly pulling on the battery and wires simultaneously.

The small black and white wire with the white plug will not be connected to the drone, just be sure the plug does not get stuck in the battery compartment and damaged while removing the battery. This is rarely an issue.

Step 4

Disconnect the two ends of the wires by lightly pulling them apart.

Disconnect the two ends of the wires by lightly pulling them apart.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    stephen R masalewicz

Member since: 02/15/2018

270 Reputation

                                      2 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       UW Stout, Team S8-G4, Ogden Spring 2018                        

                                                  Member of UW Stout, Team S8-G4, Ogden Spring 2018 



                    UWSTOUT-OGDEN-S18S8G4                     


                                            4 Members                     


                                            6 Guides authored

Introduction#

#

#

#

#

#

#

Team#

#

Introduction

Team