Protocol Galileo Stealth Light Emitting Diode Led Replacement Repair Guide

Difficulty

Moderate

Steps

5

Time Required

                          10 - 25 minutes            

Sections

2

• Housing
• 2 steps
• Light Emitting Diode (LED)
• 3 steps

Flags

0

• BackProtocol Galileo Stealth

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Housing               

• Remove the 8mm long Phillips #0 screws (24 total) from the lower housing unit.
• Take care to place the screws in a safe place to prevent losing them.

Remove the 8mm long Phillips #0 screws (24 total) from the lower housing unit.

Take care to place the screws in a safe place to prevent losing them.

1024

Step 2

• Separate the upper and lower housing units by lightly pulling the two housing units apart.

Separate the upper and lower housing units by lightly pulling the two housing units apart.

Step 3

              Light Emitting Diode (LED)               

• Remove 6mm Phillips #0 screw from the LED strip.

Remove 6mm Phillips #0 screw from the LED strip.

Step 4

• Remove the LED strip from the housing by applying light pressure away from the lower housing with the plastic opening tool.
• Take care not to damage the LED strip when removing it from the lower housing.

Remove the LED strip from the housing by applying light pressure away from the lower housing with the plastic opening tool.

Take care not to damage the LED strip when removing it from the lower housing.

Step 5

• Unclip the wire plug from the motherboard by applying light pressure away from the motherboard with the plastic spudger.
• Avoid damaging the wire plug, wires, and motherboard when removing the wire plug.

Unclip the wire plug from the motherboard by applying light pressure away from the motherboard with the plastic spudger.

Avoid damaging the wire plug, wires, and motherboard when removing the wire plug.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Matthew Selting                     

Member since: 02/15/2018

432 Reputation

                                      4 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       UW Stout, Team S8-G4, Ogden Spring 2018                        

                                                  Member of UW Stout, Team S8-G4, Ogden Spring 2018 



                    UWSTOUT-OGDEN-S18S8G4                     


                                            4 Members                     


                                            6 Guides authored