Difficulty
Difficult
Steps
4
Time Required
20 - 30 minutes
Sections
1
- Controller Switch
- 4 steps
Flags
0
BackProtocol Neo-Drone AP
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Controller Switch
- Remove the single 6.5mm Phillips #1 screw from the battery cover.
- Remove the three AAA batteries.
Remove the single 6.5mm Phillips #1 screw from the battery cover.
Remove the three AAA batteries.
1024
Step 2
- Remove seven 6.5mm Phillips #1 screws from the back panel.
- Pull the back panel up to separate it from the front panel.
Remove seven 6.5mm Phillips #1 screws from the back panel.
Pull the back panel up to separate it from the front panel.
Step 3
- Remove three 4.5mm Phillips #1 screws from the motherboard.
- Pull the motherboard out of the case.
Remove three 4.5mm Phillips #1 screws from the motherboard.
Pull the motherboard out of the case.
Step 4
- Here is a link to the iFixit Soldering Guide
- Use a soldering iron to remove the solder form the motherboard.
Here is a link to the iFixit Soldering Guide
Use a soldering iron to remove the solder form the motherboard.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Andrew
Member since: 07/05/2018
291 Reputation
2 Guides authored
Badges:
5
+2 more badges
Team
IUPUI, Team S2-G3, Harley Summer 2018
Member of IUPUI, Team S2-G3, Harley Summer 2018
IUPUI-HARLEY-SU18S2G3
4 Members
2 Guides authored
