Difficulty
Difficult
Steps
6
Time Required
10 - 15 minutes
Sections
1
- Motor
- 6 steps
Flags
0
BackProtocol Neo-Drone AP
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Motor
- Remove the four blades by pulling them off of the motors.
Remove the four blades by pulling them off of the motors.
1024
Step 2
- Remove the blade guards by pushing the guards downward towards the padded feet.
Remove the blade guards by pushing the guards downward towards the padded feet.
Step 3
- Remove the four 4.5mm Phillips #0 screws from the back panel.
Remove the four 4.5mm Phillips #0 screws from the back panel.
Step 4
- Use the flat end of a spudger to pry apart the the two pieces.
- Lift the back panel up to separate it from the front panel.
Use the flat end of a spudger to pry apart the the two pieces.
Lift the back panel up to separate it from the front panel.
Step 5
- Pull the four motors out of the case.
- The motors are still soldered to the motherboard.
Pull the four motors out of the case.
The motors are still soldered to the motherboard.
Step 6
- Here is a link to the iFixit Soldering Guide
- Use a soldering iron to desolder the motors from the motherboard.
Here is a link to the iFixit Soldering Guide
Use a soldering iron to desolder the motors from the motherboard.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Andrew
Member since: 07/05/2018
291 Reputation
2 Guides authored
Badges:
5
+2 more badges
Team
IUPUI, Team S2-G3, Harley Summer 2018
Member of IUPUI, Team S2-G3, Harley Summer 2018
IUPUI-HARLEY-SU18S2G3
4 Members
2 Guides authored
